PM / Domains: Set device state to "active" during system resume
The runtime PM status of devices in a power domain that is not
powered off in pm_genpd_complete() should be set to "active", because
those devices are operational at this point. Some of them may not be
in use, though, so make pm_genpd_complete() call pm_runtime_idle()
in addition to pm_runtime_set_active() for each of them.
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
diff --git a/drivers/base/power/domain.c b/drivers/base/power/domain.c
index 1f1a7d8..0e7e91b 100644
--- a/drivers/base/power/domain.c
+++ b/drivers/base/power/domain.c
@@ -786,7 +786,9 @@
if (run_complete) {
pm_generic_complete(dev);
+ pm_runtime_set_active(dev);
pm_runtime_enable(dev);
+ pm_runtime_idle(dev);
}
}