e1000e: enable/disable ASPM L0s and L1 and ERT according to hardware errata
Prompted by a previous patch submitted by Matthew Garret <mjg@redhat.com>,
further digging into errata documentation reveals the current enabling or
disabling of ASPM L0s and L1 states for certain parts supported by this
driver are incorrect. 82571 and 82572 should always disable L1. For
standard frames, 82573/82574/82583 can enable L1 but L0s must be disabled,
and for jumbo frames 82573/82574 must disable L1. This allows for some
parts to enable L1 in certain configurations leading to better power
savings.
Also according to the same errata, Early Receive (ERT) should be disabled
on 82573 when using jumbo frames.
Cc: Matthew Garret <mjg@redhat.com>
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e1000e/82571.c b/drivers/net/e1000e/82571.c
index 712ccc6..9015555 100644
--- a/drivers/net/e1000e/82571.c
+++ b/drivers/net/e1000e/82571.c
@@ -336,7 +336,6 @@
struct e1000_hw *hw = &adapter->hw;
static int global_quad_port_a; /* global port a indication */
struct pci_dev *pdev = adapter->pdev;
- u16 eeprom_data = 0;
int is_port_b = er32(STATUS) & E1000_STATUS_FUNC_1;
s32 rc;
@@ -387,16 +386,15 @@
if (pdev->device == E1000_DEV_ID_82571EB_SERDES_QUAD)
adapter->flags &= ~FLAG_HAS_WOL;
break;
-
case e1000_82573:
+ case e1000_82574:
+ case e1000_82583:
+ /* Disable ASPM L0s due to hardware errata */
+ e1000e_disable_aspm(adapter->pdev, PCIE_LINK_STATE_L0S);
+
if (pdev->device == E1000_DEV_ID_82573L) {
- if (e1000_read_nvm(&adapter->hw, NVM_INIT_3GIO_3, 1,
- &eeprom_data) < 0)
- break;
- if (!(eeprom_data & NVM_WORD1A_ASPM_MASK)) {
- adapter->flags |= FLAG_HAS_JUMBO_FRAMES;
- adapter->max_hw_frame_size = DEFAULT_JUMBO;
- }
+ adapter->flags |= FLAG_HAS_JUMBO_FRAMES;
+ adapter->max_hw_frame_size = DEFAULT_JUMBO;
}
break;
default:
@@ -1792,6 +1790,7 @@
| FLAG_RESET_OVERWRITES_LAA /* errata */
| FLAG_TARC_SPEED_MODE_BIT /* errata */
| FLAG_APME_CHECK_PORT_B,
+ .flags2 = FLAG2_DISABLE_ASPM_L1, /* errata 13 */
.pba = 38,
.max_hw_frame_size = DEFAULT_JUMBO,
.get_variants = e1000_get_variants_82571,
@@ -1809,6 +1808,7 @@
| FLAG_RX_CSUM_ENABLED
| FLAG_HAS_CTRLEXT_ON_LOAD
| FLAG_TARC_SPEED_MODE_BIT, /* errata */
+ .flags2 = FLAG2_DISABLE_ASPM_L1, /* errata 13 */
.pba = 38,
.max_hw_frame_size = DEFAULT_JUMBO,
.get_variants = e1000_get_variants_82571,
@@ -1820,13 +1820,11 @@
struct e1000_info e1000_82573_info = {
.mac = e1000_82573,
.flags = FLAG_HAS_HW_VLAN_FILTER
- | FLAG_HAS_JUMBO_FRAMES
| FLAG_HAS_WOL
| FLAG_APME_IN_CTRL3
| FLAG_RX_CSUM_ENABLED
| FLAG_HAS_SMART_POWER_DOWN
| FLAG_HAS_AMT
- | FLAG_HAS_ERT
| FLAG_HAS_SWSM_ON_LOAD,
.pba = 20,
.max_hw_frame_size = ETH_FRAME_LEN + ETH_FCS_LEN,