ARM: dt: t30 cardhu: set pinmux and power for wlan
Configure pinmux as required for WiFi.
Enable the SDHCI1 controller for a02 and a04 board, which is connected to the
WiFi module.
For now, always enable the regulator that provides power to the Wifi module.
Signed-off-by: Wei Ni <wni@nvidia.com>
Signed-off-by: Stephen Warren <swarren@nvidia.com>
diff --git a/arch/arm/boot/dts/tegra30-cardhu.dtsi b/arch/arm/boot/dts/tegra30-cardhu.dtsi
index b1271a8..b245e6c 100644
--- a/arch/arm/boot/dts/tegra30-cardhu.dtsi
+++ b/arch/arm/boot/dts/tegra30-cardhu.dtsi
@@ -52,6 +52,22 @@
nvidia,pull = <2>;
nvidia,tristate = <0>;
};
+ sdmmc3_clk_pa6 {
+ nvidia,pins = "sdmmc3_clk_pa6";
+ nvidia,function = "sdmmc3";
+ nvidia,pull = <0>;
+ nvidia,tristate = <0>;
+ };
+ sdmmc3_cmd_pa7 {
+ nvidia,pins = "sdmmc3_cmd_pa7",
+ "sdmmc3_dat0_pb7",
+ "sdmmc3_dat1_pb6",
+ "sdmmc3_dat2_pb5",
+ "sdmmc3_dat3_pb4";
+ nvidia,function = "sdmmc3";
+ nvidia,pull = <2>;
+ nvidia,tristate = <0>;
+ };
sdmmc4_clk_pcc4 {
nvidia,pins = "sdmmc4_clk_pcc4",
"sdmmc4_rst_n_pcc3";
@@ -81,6 +97,15 @@
nvidia,pull = <0>;
nvidia,tristate = <0>;
};
+ sdio3 {
+ nvidia,pins = "drive_sdio3";
+ nvidia,high-speed-mode = <0>;
+ nvidia,schmitt = <0>;
+ nvidia,pull-down-strength = <46>;
+ nvidia,pull-up-strength = <42>;
+ nvidia,slew-rate-rising = <1>;
+ nvidia,slew-rate-falling = <1>;
+ };
};
};
@@ -384,6 +409,8 @@
regulator-name = "vdd_com";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
+ regulator-always-on;
+ regulator-boot-on;
enable-active-high;
gpio = <&gpio 24 0>; /* gpio PD0 */
vin-supply = <&sys_3v3_reg>;