[PATCH] pcmcia: remove unneeded Vcc pseudo setting
As we do not allow setting Vcc in the pcmcia core, and Vpp1 and
Vpp2 can only be set to the same value, a lot of code can be
streamlined.
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/wireless/hostap/hostap_cs.c b/drivers/net/wireless/hostap/hostap_cs.c
index 0fb62518..69024bfb 100644
--- a/drivers/net/wireless/hostap/hostap_cs.c
+++ b/drivers/net/wireless/hostap/hostap_cs.c
@@ -512,7 +512,6 @@
memset(link, 0, sizeof(dev_link_t));
PDEBUG(DEBUG_HW, "%s: setting Vcc=33 (constant)\n", dev_info);
- link->conf.Vcc = 33;
link->conf.IntType = INT_MEMORY_AND_IO;
link->handle = p_dev;
@@ -603,9 +602,6 @@
CS_CHECK(GetConfigurationInfo,
pcmcia_get_configuration_info(link->handle, &conf));
- PDEBUG(DEBUG_HW, "%s: %s Vcc=%d (from config)\n", dev_info,
- ignore_cis_vcc ? "ignoring" : "setting", conf.Vcc);
- link->conf.Vcc = conf.Vcc;
/* Look for an appropriate configuration table entry in the CIS */
tuple.DesiredTuple = CISTPL_CFTABLE_ENTRY;
@@ -650,10 +646,10 @@
}
if (cfg->vpp1.present & (1 << CISTPL_POWER_VNOM))
- link->conf.Vpp1 = link->conf.Vpp2 =
+ link->conf.Vpp =
cfg->vpp1.param[CISTPL_POWER_VNOM] / 10000;
else if (dflt.vpp1.present & (1 << CISTPL_POWER_VNOM))
- link->conf.Vpp1 = link->conf.Vpp2 =
+ link->conf.Vpp =
dflt.vpp1.param[CISTPL_POWER_VNOM] / 10000;
/* Do we need to allocate an interrupt? */
@@ -745,12 +741,11 @@
dev->base_addr = link->io.BasePort1;
/* Finally, report what we've done */
- printk(KERN_INFO "%s: index 0x%02x: Vcc %d.%d",
- dev_info, link->conf.ConfigIndex,
- link->conf.Vcc / 10, link->conf.Vcc % 10);
- if (link->conf.Vpp1)
- printk(", Vpp %d.%d", link->conf.Vpp1 / 10,
- link->conf.Vpp1 % 10);
+ printk(KERN_INFO "%s: index 0x%02x: ",
+ dev_info, link->conf.ConfigIndex);
+ if (link->conf.Vpp)
+ printk(", Vpp %d.%d", link->conf.Vpp / 10,
+ link->conf.Vpp % 10);
if (link->conf.Attributes & CONF_ENABLE_IRQ)
printk(", irq %d", link->irq.AssignedIRQ);
if (link->io.NumPorts1)