ASoC: Add I/O control bus information to factored out cache setup
While writes tend to be able to use a fairly bus independant format to
do the writes reads are all bus specific. To allow us to factor out
this code include the bus type as a parameter when setting up the
cache.
Initially just use this to factor out hw_write_t for I2C.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/sound/soc/codecs/wm8510.c b/sound/soc/codecs/wm8510.c
index 7a169bf..4ca724f 100644
--- a/sound/soc/codecs/wm8510.c
+++ b/sound/soc/codecs/wm8510.c
@@ -564,7 +564,8 @@
* initialise the WM8510 driver
* register the mixer and dsp interfaces with the kernel
*/
-static int wm8510_init(struct snd_soc_device *socdev)
+static int wm8510_init(struct snd_soc_device *socdev,
+ enum snd_soc_control_type control)
{
struct snd_soc_codec *codec = socdev->card->codec;
int ret = 0;
@@ -580,7 +581,7 @@
if (codec->reg_cache == NULL)
return -ENOMEM;
- ret = snd_soc_codec_set_cache_io(codec, 7, 9);
+ ret = snd_soc_codec_set_cache_io(codec, 7, 9, control);
if (ret < 0) {
printk(KERN_ERR "wm8510: failed to set cache I/O: %d\n",
ret);
@@ -635,7 +636,7 @@
i2c_set_clientdata(i2c, codec);
codec->control_data = i2c;
- ret = wm8510_init(socdev);
+ ret = wm8510_init(socdev, SND_SOC_I2C);
if (ret < 0)
pr_err("failed to initialise WM8510\n");
@@ -715,7 +716,7 @@
codec->control_data = spi;
- ret = wm8510_init(socdev);
+ ret = wm8510_init(socdev, SND_SOC_SPI);
if (ret < 0)
dev_err(&spi->dev, "failed to initialise WM8510\n");
@@ -784,7 +785,6 @@
wm8510_socdev = socdev;
#if defined(CONFIG_I2C) || defined(CONFIG_I2C_MODULE)
if (setup->i2c_address) {
- codec->hw_write = (hw_write_t)i2c_master_send;
ret = wm8510_add_i2c_device(pdev, setup);
}
#endif