{nl,cfg,mac}80211: Allow user to see/configure HT protection mode
This patch introduces a new mesh configuration parameter "ht_opmode" and will
allow user to check the current HT protection mode selected. Users could
configure the protection mode by the command "iw mesh_iface set mesh_param
mesh_ht_protection_mode=2". The default protection mode of mesh is set to
non-HT mixed mode.
Signed-off-by: Ashok Nagarajan <ashok@cozybit.com>
Reviewed-by: Thomas Pedersen <thomas@cozybit.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/include/linux/nl80211.h b/include/linux/nl80211.h
index 1335084..2540e86 100644
--- a/include/linux/nl80211.h
+++ b/include/linux/nl80211.h
@@ -2154,6 +2154,8 @@
* @NL80211_MESHCONF_SYNC_OFFSET_MAX_NEIGHBOR: maximum number of neighbors
* to synchronize to for 11s default synchronization method (see 11C.12.2.2)
*
+ * @NL80211_MESHCONF_HT_OPMODE: set mesh HT protection mode.
+ *
* @__NL80211_MESHCONF_ATTR_AFTER_LAST: internal use
*/
enum nl80211_meshconf_params {
@@ -2179,6 +2181,7 @@
NL80211_MESHCONF_FORWARDING,
NL80211_MESHCONF_RSSI_THRESHOLD,
NL80211_MESHCONF_SYNC_OFFSET_MAX_NEIGHBOR,
+ NL80211_MESHCONF_HT_OPMODE,
/* keep last */
__NL80211_MESHCONF_ATTR_AFTER_LAST,