spi: add spi_master flag word
Add a new spi_master.flags word listing constraints relevant to that
controller. Define the first constraint bit: a half duplex restriction.
Include that constraint in the OMAP1 MicroWire controller driver.
Have the mmc_spi host be the first customer of this flag. Its coding
relies heavily on full duplex transfers, so it must fail when the
underlying controller driver won't perform them.
(The spi_write_then_read routine could use it too: use the
temporarily-withdrawn full-duplex speedup unless this flag is set, in
which case the existing code applies. Similarly, any spi_master
implementing only SPI_3WIRE should set the flag.)
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Cc: Marek Szyprowski <m.szyprowski@samsung.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/mmc/host/mmc_spi.c b/drivers/mmc/host/mmc_spi.c
index 240608c..a461017 100644
--- a/drivers/mmc/host/mmc_spi.c
+++ b/drivers/mmc/host/mmc_spi.c
@@ -1313,6 +1313,12 @@
struct mmc_spi_host *host;
int status;
+ /* We rely on full duplex transfers, mostly to reduce
+ * per-transfer overheads (by making fewer transfers).
+ */
+ if (spi->master->flags & SPI_MASTER_HALF_DUPLEX)
+ return -EINVAL;
+
/* MMC and SD specs only seem to care that sampling is on the
* rising edge ... meaning SPI modes 0 or 3. So either SPI mode
* should be legit. We'll use mode 0 since the steady state is 0,
diff --git a/drivers/spi/omap_uwire.c b/drivers/spi/omap_uwire.c
index aa90ddb..8980a56 100644
--- a/drivers/spi/omap_uwire.c
+++ b/drivers/spi/omap_uwire.c
@@ -514,6 +514,8 @@
/* the spi->mode bits understood by this driver: */
master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
+ master->flags = SPI_MASTER_HALF_DUPLEX;
+
master->bus_num = 2; /* "official" */
master->num_chipselect = 4;
master->setup = uwire_setup;
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h
index 743c933..c47c4b4 100644
--- a/include/linux/spi/spi.h
+++ b/include/linux/spi/spi.h
@@ -250,6 +250,10 @@
/* spi_device.mode flags understood by this controller driver */
u16 mode_bits;
+ /* other constraints relevant to this driver */
+ u16 flags;
+#define SPI_MASTER_HALF_DUPLEX BIT(0) /* can't do full duplex */
+
/* Setup mode and clock, etc (spi driver may call many times).
*
* IMPORTANT: this may be called when transfers to another