hwmon: (it87) Add support for IT8628E

IT8628E is functionally identical to IT8620E.

Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
diff --git a/Documentation/hwmon/it87 b/Documentation/hwmon/it87
index 733296d..fff6f6b 100644
--- a/Documentation/hwmon/it87
+++ b/Documentation/hwmon/it87
@@ -9,6 +9,9 @@
   * IT8620E
     Prefix: 'it8620'
     Addresses scanned: from Super I/O config space (8 I/O ports)
+  * IT8628E
+    Prefix: 'it8628'
+    Addresses scanned: from Super I/O config space (8 I/O ports)
     Datasheet: Not publicly available
   * IT8705F
     Prefix: 'it87'
@@ -114,8 +117,8 @@
 Description
 -----------
 
-This driver implements support for the IT8603E, IT8620E, IT8623E, IT8705F,
-IT8712F, IT8716F, IT8718F, IT8720F, IT8721F, IT8726F, IT8728F, IT8732F,
+This driver implements support for the IT8603E, IT8620E, IT8623E, IT8628E,
+IT8705F, IT8712F, IT8716F, IT8718F, IT8720F, IT8721F, IT8726F, IT8728F, IT8732F,
 IT8758E, IT8771E, IT8772E, IT8781F, IT8782F, IT8783E/F, IT8786E, IT8790E, and
 SiS950 chips.
 
@@ -158,8 +161,8 @@
 IT8728F. It only supports 3 fans, 16-bit fan mode, and the full speed mode
 of the fan is not supported (value 0 of pwmX_enable).
 
-The IT8620E is another custom design, hardware monitoring part is similar to
-IT8728F. It only supports 16-bit fan mode.
+The IT8620E and IT8628E are custom designs, hardware monitoring part is similar
+to IT8728F. It only supports 16-bit fan mode. Both chips support up to 6 fans.
 
 The IT8790E supports up to 3 fans. 16-bit fan mode is always enabled.
 
@@ -187,8 +190,8 @@
 2.8 volts with a resolution of 0.0109 volt.  The battery voltage in8 does not
 have limit registers.
 
-On the IT8603E, IT8721F/IT8758E, IT8732F, IT8781F, IT8782F, and IT8783E/F, some
-voltage inputs are internal and scaled inside the chip:
+On the IT8603E, IT8620E, IT8628E, IT8721F/IT8758E, IT8732F, IT8781F, IT8782F,
+and IT8783E/F, some voltage inputs are internal and scaled inside the chip:
 * in3 (optional)
 * in7 (optional for IT8781F, IT8782F, and IT8783E/F)
 * in8 (always)