ARM: mx5/mx51_babbage: Use gpio_request_array for USBH1 pins
Instead of using gpio_request followed by gpio_direction_output use gpio_request_array
when requesting multiple pins.
Also fixed the location of the delay for the reset and make the BABBAGE_USB_PHY_RESET to toggle.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-mx5/board-mx51_babbage.c b/arch/arm/mach-mx5/board-mx51_babbage.c
index 7b919bc..770f74b5 100644
--- a/arch/arm/mach-mx5/board-mx51_babbage.c
+++ b/arch/arm/mach-mx5/board-mx51_babbage.c
@@ -172,6 +172,11 @@
.bitrate = 400000,
};
+static struct gpio mx51_babbage_usbh1_gpios[] = {
+ { BABBAGE_USBH1_STP, GPIOF_OUT_INIT_LOW, "usbh1_stp" },
+ { BABBAGE_USB_PHY_RESET, GPIOF_OUT_INIT_LOW, "usbh1_phy_reset" },
+};
+
static int gpio_usbh1_active(void)
{
iomux_v3_cfg_t usbh1stp_gpio = MX51_PAD_USBH1_STP__GPIO1_27;
@@ -179,25 +184,19 @@
/* Set USBH1_STP to GPIO and toggle it */
mxc_iomux_v3_setup_pad(usbh1stp_gpio);
- ret = gpio_request(BABBAGE_USBH1_STP, "usbh1_stp");
+ ret = gpio_request_array(mx51_babbage_usbh1_gpios,
+ ARRAY_SIZE(mx51_babbage_usbh1_gpios));
if (ret) {
- pr_debug("failed to get MX51_PAD_USBH1_STP__GPIO_1_27: %d\n", ret);
+ pr_debug("failed to get USBH1 pins: %d\n", ret);
return ret;
}
- gpio_direction_output(BABBAGE_USBH1_STP, 0);
- gpio_set_value(BABBAGE_USBH1_STP, 1);
+
msleep(100);
- gpio_free(BABBAGE_USBH1_STP);
-
- /* De-assert USB PHY RESETB */
- ret = gpio_request(BABBAGE_USB_PHY_RESET, "phy_reset");
-
- if (ret) {
- pr_debug("failed to get MX51_PAD_EIM_D21__GPIO_2_5: %d\n", ret);
- return ret;
- }
- gpio_direction_output(BABBAGE_USB_PHY_RESET, 1);
+ gpio_set_value(BABBAGE_USBH1_STP, 1);
+ gpio_set_value(BABBAGE_USB_PHY_RESET, 1);
+ gpio_free_array(mx51_babbage_usbh1_gpios,
+ ARRAY_SIZE(mx51_babbage_usbh1_gpios));
return 0;
}