ARM: 7227/1: mmc: mmci: Prepare for SDIO before setting up DMA job
Move the SDIO preparation to be done before the DMA job is setup.
This makes it possible to do DMA for SDIO transfers as well as the
earlier supported pio mode.
Signed-off-by: Ulf Hansson <ulf.hansson@stericsson.com>
Signed-off-by: Stefan Nilsson XK <stefan.xk.nilsson@stericsson.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index 6a21fc0..b09ccb7 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -615,6 +615,11 @@
if (data->flags & MMC_DATA_READ)
datactrl |= MCI_DPSM_DIRECTION;
+ /* The ST Micro variants has a special bit to enable SDIO */
+ if (variant->sdio && host->mmc->card)
+ if (mmc_card_sdio(host->mmc->card))
+ datactrl |= MCI_ST_DPSM_SDIOEN;
+
/*
* Attempt to use DMA operation mode, if this
* should fail, fall back to PIO mode
@@ -643,11 +648,6 @@
irqmask = MCI_TXFIFOHALFEMPTYMASK;
}
- /* The ST Micro variants has a special bit to enable SDIO */
- if (variant->sdio && host->mmc->card)
- if (mmc_card_sdio(host->mmc->card))
- datactrl |= MCI_ST_DPSM_SDIOEN;
-
writel(datactrl, base + MMCIDATACTRL);
writel(readl(base + MMCIMASK0) & ~MCI_DATAENDMASK, base + MMCIMASK0);
mmci_set_mask1(host, irqmask);