i2c: at91: Add device tree property to set clock-frequency
This adds the ability to set "clock-frequency" in the device tree for the at91
i2cbus following the naming of other i2c bus implementations. If the property
is not set,the clock frequency will default to the previously used define
of 100KHz.
Signed-off-by: Marek Roszko <mark.roszko@gmail.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/drivers/i2c/busses/i2c-at91.c b/drivers/i2c/busses/i2c-at91.c
index 56baf48..e95f9ba 100644
--- a/drivers/i2c/busses/i2c-at91.c
+++ b/drivers/i2c/busses/i2c-at91.c
@@ -32,7 +32,7 @@
#include <linux/slab.h>
#include <linux/platform_data/dma-atmel.h>
-#define TWI_CLK_HZ 100000 /* max 400 Kbits/s */
+#define DEFAULT_TWI_CLK_HZ 100000 /* max 400 Kbits/s */
#define AT91_I2C_TIMEOUT msecs_to_jiffies(100) /* transfer timeout */
#define AT91_I2C_DMA_THRESHOLD 8 /* enable DMA if transfer size is bigger than this threshold */
@@ -711,6 +711,7 @@
struct resource *mem;
int rc;
u32 phy_addr;
+ u32 bus_clk_rate;
dev = devm_kzalloc(&pdev->dev, sizeof(*dev), GFP_KERNEL);
if (!dev)
@@ -756,7 +757,12 @@
dev->use_dma = true;
}
- at91_calc_twi_clock(dev, TWI_CLK_HZ);
+ rc = of_property_read_u32(dev->dev->of_node, "clock-frequency",
+ &bus_clk_rate);
+ if (rc)
+ bus_clk_rate = DEFAULT_TWI_CLK_HZ;
+
+ at91_calc_twi_clock(dev, bus_clk_rate);
at91_init_twi_bus(dev);
snprintf(dev->adapter.name, sizeof(dev->adapter.name), "AT91");