spi/topcliff-pch: Fix DMA channel
bus_num might be asigned dynamically to e.g. 32766. In this case the
calculated DMA channel based on SPI bus number is bogus. Use SPI channel
number instead for calculation.
Signed-off-by: Alexander Stein <alexander.stein@systec-electronic.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/spi-topcliff-pch.c b/drivers/spi/spi-topcliff-pch.c
index 2e7f38c..3383008c 100644
--- a/drivers/spi/spi-topcliff-pch.c
+++ b/drivers/spi/spi-topcliff-pch.c
@@ -915,7 +915,7 @@
/* Set Tx DMA */
param = &dma->param_tx;
param->dma_dev = &dma_dev->dev;
- param->chan_id = data->master->bus_num * 2; /* Tx = 0, 2 */
+ param->chan_id = data->ch * 2; /* Tx = 0, 2 */;
param->tx_reg = data->io_base_addr + PCH_SPDWR;
param->width = width;
chan = dma_request_channel(mask, pch_spi_filter, param);
@@ -930,7 +930,7 @@
/* Set Rx DMA */
param = &dma->param_rx;
param->dma_dev = &dma_dev->dev;
- param->chan_id = data->master->bus_num * 2 + 1; /* Rx = Tx + 1 */
+ param->chan_id = data->ch * 2 + 1; /* Rx = Tx + 1 */;
param->rx_reg = data->io_base_addr + PCH_SPDRR;
param->width = width;
chan = dma_request_channel(mask, pch_spi_filter, param);