gru: send cross partition interrupts using the gru
GRU Message queue instructions are used to deliver messages to other SSIs
within the numalink domain. In most cases, a single GRU mesq instruction
will deliver both the message AND an interrupt to notify the other SSI
that a messsage is present. In some cases, however, the interrupt must be
sent explicitly.
To improve resilency, the GRU driver should send these explicit interrupts
using the GRU to write the remote chipset register. Current code sends
the interrupt using a cpu instruction to write the chipset register.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/misc/sgi-gru/grukservices.c b/drivers/misc/sgi-gru/grukservices.c
index bfbf8fd..34749ee 100644
--- a/drivers/misc/sgi-gru/grukservices.c
+++ b/drivers/misc/sgi-gru/grukservices.c
@@ -31,6 +31,7 @@
#include <linux/interrupt.h>
#include <linux/uaccess.h>
#include <linux/delay.h>
+#include <asm/io_apic.h>
#include "gru.h"
#include "grulib.h"
#include "grutables.h"
@@ -566,7 +567,7 @@
mqd->mq = mq;
mqd->mq_gpa = uv_gpa(mq);
mqd->qlines = qlines;
- mqd->interrupt_pnode = UV_NASID_TO_PNODE(nasid);
+ mqd->interrupt_pnode = nasid >> 1;
mqd->interrupt_vector = vector;
mqd->interrupt_apicid = apicid;
return 0;
@@ -703,18 +704,6 @@
}
/*
- * Send a cross-partition interrupt to the SSI that contains the target
- * message queue. Normally, the interrupt is automatically delivered by hardware
- * but some error conditions require explicit delivery.
- */
-static void send_message_queue_interrupt(struct gru_message_queue_desc *mqd)
-{
- if (mqd->interrupt_vector)
- uv_hub_send_ipi(mqd->interrupt_pnode, mqd->interrupt_apicid,
- mqd->interrupt_vector);
-}
-
-/*
* Handle a PUT failure. Note: if message was a 2-line message, one of the
* lines might have successfully have been written. Before sending the
* message, "present" must be cleared in BOTH lines to prevent the receiver
@@ -723,7 +712,8 @@
static int send_message_put_nacked(void *cb, struct gru_message_queue_desc *mqd,
void *mesg, int lines)
{
- unsigned long m;
+ unsigned long m, *val = mesg, gpa, save;
+ int ret;
m = mqd->mq_gpa + (gru_get_amo_value_head(cb) << 6);
if (lines == 2) {
@@ -734,7 +724,26 @@
gru_vstore(cb, m, gru_get_tri(mesg), XTYPE_CL, lines, 1, IMA);
if (gru_wait(cb) != CBS_IDLE)
return MQE_UNEXPECTED_CB_ERR;
- send_message_queue_interrupt(mqd);
+
+ if (!mqd->interrupt_vector)
+ return MQE_OK;
+
+ /*
+ * Send a cross-partition interrupt to the SSI that contains the target
+ * message queue. Normally, the interrupt is automatically delivered by
+ * hardware but some error conditions require explicit delivery.
+ * Use the GRU to deliver the interrupt. Otherwise partition failures
+ * could cause unrecovered errors.
+ */
+ gpa = uv_global_gru_mmr_address(mqd->interrupt_pnode, UVH_IPI_INT);
+ save = *val;
+ *val = uv_hub_ipi_value(mqd->interrupt_apicid, mqd->interrupt_vector,
+ dest_Fixed);
+ gru_vstore_phys(cb, gpa, gru_get_tri(mesg), IAA_REGISTER, IMA);
+ ret = gru_wait(cb);
+ *val = save;
+ if (ret != CBS_IDLE)
+ return MQE_UNEXPECTED_CB_ERR;
return MQE_OK;
}