blob: 703a29586a7ad100be40309c655aa2f474396b83 [file] [log] [blame]
/*
* Renesas R-Car USB phy driver
*
* Copyright (C) 2012 Renesas Solutions Corp.
* Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/delay.h>
#include <linux/io.h>
#include <linux/usb/otg.h>
#include <linux/platform_device.h>
#include <linux/spinlock.h>
#include <linux/module.h>
/* USBH common register */
#define USBPCTRL0 0x0800
#define USBPCTRL1 0x0804
#define USBST 0x0808
#define USBEH0 0x080C
#define USBOH0 0x081C
#define USBCTL0 0x0858
#define EIIBC1 0x0094
#define EIIBC2 0x009C
/* USBPCTRL1 */
#define PHY_RST (1 << 2)
#define PLL_ENB (1 << 1)
#define PHY_ENB (1 << 0)
/* USBST */
#define ST_ACT (1 << 31)
#define ST_PLL (1 << 30)
struct rcar_usb_phy_priv {
struct usb_phy phy;
spinlock_t lock;
void __iomem *reg0;
void __iomem *reg1;
int counter;
};
#define usb_phy_to_priv(p) container_of(p, struct rcar_usb_phy_priv, phy)
/*
* USB initial/install operation.
*
* This function setup USB phy.
* The used value and setting order came from
* [USB :: Initial setting] on datasheet.
*/
static int rcar_usb_phy_init(struct usb_phy *phy)
{
struct rcar_usb_phy_priv *priv = usb_phy_to_priv(phy);
struct device *dev = phy->dev;
void __iomem *reg0 = priv->reg0;
void __iomem *reg1 = priv->reg1;
int i;
u32 val;
unsigned long flags;
spin_lock_irqsave(&priv->lock, flags);
if (priv->counter++ == 0) {
/*
* USB phy start-up
*/
/* (1) USB-PHY standby release */
iowrite32(PHY_ENB, (reg0 + USBPCTRL1));
/* (2) start USB-PHY internal PLL */
iowrite32(PHY_ENB | PLL_ENB, (reg0 + USBPCTRL1));
/* (3) USB module status check */
for (i = 0; i < 1024; i++) {
udelay(10);
val = ioread32(reg0 + USBST);
if (val == (ST_ACT | ST_PLL))
break;
}
if (val != (ST_ACT | ST_PLL)) {
dev_err(dev, "USB phy not ready\n");
goto phy_init_end;
}
/* (4) USB-PHY reset clear */
iowrite32(PHY_ENB | PLL_ENB | PHY_RST, (reg0 + USBPCTRL1));
/* set platform specific port settings */
iowrite32(0x00000000, (reg0 + USBPCTRL0));
/*
* EHCI IP internal buffer setting
* EHCI IP internal buffer enable
*
* These are recommended value of a datasheet
* see [USB :: EHCI internal buffer setting]
*/
iowrite32(0x00ff0040, (reg0 + EIIBC1));
iowrite32(0x00ff0040, (reg1 + EIIBC1));
iowrite32(0x00000001, (reg0 + EIIBC2));
iowrite32(0x00000001, (reg1 + EIIBC2));
/*
* Bus alignment settings
*/
/* (1) EHCI bus alignment (little endian) */
iowrite32(0x00000000, (reg0 + USBEH0));
/* (1) OHCI bus alignment (little endian) */
iowrite32(0x00000000, (reg0 + USBOH0));
}
phy_init_end:
spin_unlock_irqrestore(&priv->lock, flags);
return 0;
}
static void rcar_usb_phy_shutdown(struct usb_phy *phy)
{
struct rcar_usb_phy_priv *priv = usb_phy_to_priv(phy);
void __iomem *reg0 = priv->reg0;
unsigned long flags;
spin_lock_irqsave(&priv->lock, flags);
if (priv->counter-- == 1) { /* last user */
iowrite32(0x00000000, (reg0 + USBPCTRL0));
iowrite32(0x00000000, (reg0 + USBPCTRL1));
}
spin_unlock_irqrestore(&priv->lock, flags);
}
static int __devinit rcar_usb_phy_probe(struct platform_device *pdev)
{
struct rcar_usb_phy_priv *priv;
struct resource *res0, *res1;
struct device *dev = &pdev->dev;
void __iomem *reg0, *reg1;
int ret;
res0 = platform_get_resource(pdev, IORESOURCE_MEM, 0);
res1 = platform_get_resource(pdev, IORESOURCE_MEM, 1);
if (!res0 || !res1) {
dev_err(dev, "Not enough platform resources\n");
return -EINVAL;
}
/*
* CAUTION
*
* Because this phy address is also mapped under OHCI/EHCI address area,
* this driver can't use devm_request_and_ioremap(dev, res) here
*/
reg0 = devm_ioremap_nocache(dev, res0->start, resource_size(res0));
reg1 = devm_ioremap_nocache(dev, res1->start, resource_size(res1));
if (!reg0 || !reg1) {
dev_err(dev, "ioremap error\n");
return -ENOMEM;
}
priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
if (!priv) {
dev_err(dev, "priv data allocation error\n");
return -ENOMEM;
}
priv->reg0 = reg0;
priv->reg1 = reg1;
priv->counter = 0;
priv->phy.dev = dev;
priv->phy.label = dev_name(dev);
priv->phy.init = rcar_usb_phy_init;
priv->phy.shutdown = rcar_usb_phy_shutdown;
spin_lock_init(&priv->lock);
ret = usb_add_phy(&priv->phy, USB_PHY_TYPE_USB2);
if (ret < 0) {
dev_err(dev, "usb phy addition error\n");
return ret;
}
platform_set_drvdata(pdev, priv);
return ret;
}
static int __devexit rcar_usb_phy_remove(struct platform_device *pdev)
{
struct rcar_usb_phy_priv *priv = platform_get_drvdata(pdev);
usb_remove_phy(&priv->phy);
return 0;
}
static struct platform_driver rcar_usb_phy_driver = {
.driver = {
.name = "rcar_usb_phy",
},
.probe = rcar_usb_phy_probe,
.remove = rcar_usb_phy_remove,
};
module_platform_driver(rcar_usb_phy_driver);
MODULE_LICENSE("GPL v2");
MODULE_DESCRIPTION("Renesas R-Car USB phy");
MODULE_AUTHOR("Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>");