Convert selectors of GENERIC_GPIO to GPIOLIB
GENERIC_GPIO is now equivalent to GPIOLIB and features that depended on
GENERIC_GPIO can now depend on GPIOLIB to allow removal of this option.
Signed-off-by: Alexandre Courbot <acourbot@nvidia.com>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Acked-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig
index 259ef31..262cda2 100644
--- a/drivers/input/misc/Kconfig
+++ b/drivers/input/misc/Kconfig
@@ -214,7 +214,7 @@
config INPUT_GP2A
tristate "Sharp GP2AP002A00F I2C Proximity/Opto sensor driver"
depends on I2C
- depends on GENERIC_GPIO
+ depends on GPIOLIB
help
Say Y here if you have a Sharp GP2AP002A00F proximity/als combo-chip
hooked to an I2C bus.
@@ -224,7 +224,7 @@
config INPUT_GPIO_TILT_POLLED
tristate "Polled GPIO tilt switch"
- depends on GENERIC_GPIO
+ depends on GPIOLIB
select INPUT_POLLDEV
help
This driver implements support for tilt switches connected
@@ -472,7 +472,7 @@
config INPUT_GPIO_ROTARY_ENCODER
tristate "Rotary encoders connected to GPIO pins"
- depends on GPIOLIB && GENERIC_GPIO
+ depends on GPIOLIB
help
Say Y here to add support for rotary encoders connected to GPIO lines.
Check file:Documentation/input/rotary-encoder.txt for more
@@ -484,7 +484,7 @@
config INPUT_RB532_BUTTON
tristate "Mikrotik Routerboard 532 button interface"
depends on MIKROTIK_RB532
- depends on GPIOLIB && GENERIC_GPIO
+ depends on GPIOLIB
select INPUT_POLLDEV
help
Say Y here if you want support for the S1 button built into