mfd: rtsx: Read vendor setting from config space
Normally OEMs will set vendor setting to the config space of Realtek
card reader in BIOS stage. This patch reads the setting at the first,
and configure the internal registers according to it, to improve card
reader's compatibility condition.
Signed-off-by: Wei WANG <wei_wang@realsil.com.cn>
Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
diff --git a/drivers/mfd/rts5249.c b/drivers/mfd/rts5249.c
index 15dc848..d5db182 100644
--- a/drivers/mfd/rts5249.c
+++ b/drivers/mfd/rts5249.c
@@ -34,6 +34,60 @@
return val & 0x0F;
}
+static void rts5249_fill_driving(struct rtsx_pcr *pcr, u8 voltage)
+{
+ u8 driving_3v3[4][3] = {
+ {0x11, 0x11, 0x11},
+ {0x55, 0x55, 0x5C},
+ {0x99, 0x99, 0x92},
+ {0x99, 0x99, 0x92},
+ };
+ u8 driving_1v8[4][3] = {
+ {0x3C, 0x3C, 0x3C},
+ {0xB3, 0xB3, 0xB3},
+ {0xFE, 0xFE, 0xFE},
+ {0xC4, 0xC4, 0xC4},
+ };
+ u8 (*driving)[3], drive_sel;
+
+ if (voltage == OUTPUT_3V3) {
+ driving = driving_3v3;
+ drive_sel = pcr->sd30_drive_sel_3v3;
+ } else {
+ driving = driving_1v8;
+ drive_sel = pcr->sd30_drive_sel_1v8;
+ }
+
+ rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_CLK_DRIVE_SEL,
+ 0xFF, driving[drive_sel][0]);
+ rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_CMD_DRIVE_SEL,
+ 0xFF, driving[drive_sel][1]);
+ rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_DAT_DRIVE_SEL,
+ 0xFF, driving[drive_sel][2]);
+}
+
+static void rts5249_fetch_vendor_settings(struct rtsx_pcr *pcr)
+{
+ u32 reg;
+
+ rtsx_pci_read_config_dword(pcr, PCR_SETTING_REG1, ®);
+ dev_dbg(&(pcr->pci->dev), "Cfg 0x%x: 0x%x\n", PCR_SETTING_REG1, reg);
+
+ if (!rtsx_vendor_setting_valid(reg))
+ return;
+
+ pcr->aspm_en = rtsx_reg_to_aspm(reg);
+ pcr->sd30_drive_sel_1v8 = rtsx_reg_to_sd30_drive_sel_1v8(reg);
+ pcr->card_drive_sel &= 0x3F;
+ pcr->card_drive_sel |= rtsx_reg_to_card_drive_sel(reg);
+
+ rtsx_pci_read_config_dword(pcr, PCR_SETTING_REG2, ®);
+ dev_dbg(&(pcr->pci->dev), "Cfg 0x%x: 0x%x\n", PCR_SETTING_REG2, reg);
+ pcr->sd30_drive_sel_3v3 = rtsx_reg_to_sd30_drive_sel_3v3(reg);
+ if (rtsx_reg_check_reverse_socket(reg))
+ pcr->flags |= PCR_REVERSE_SOCKET;
+}
+
static int rts5249_extra_init_hw(struct rtsx_pcr *pcr)
{
rtsx_pci_init_cmd(pcr);
@@ -45,13 +99,14 @@
rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, LDO_PWR_SEL, 0x03, 0x01);
/* LED shine disabled, set initial shine cycle period */
rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, OLT_LED_CTL, 0x0F, 0x02);
- /* Correct driving */
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD,
- SD30_CLK_DRIVE_SEL, 0xFF, 0x99);
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD,
- SD30_CMD_DRIVE_SEL, 0xFF, 0x99);
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD,
- SD30_DAT_DRIVE_SEL, 0xFF, 0x92);
+ /* Configure driving */
+ rts5249_fill_driving(pcr, OUTPUT_3V3);
+ if (pcr->flags & PCR_REVERSE_SOCKET)
+ rtsx_pci_add_cmd(pcr, WRITE_REG_CMD,
+ AUTOLOAD_CFG_BASE + 3, 0xB0, 0xB0);
+ else
+ rtsx_pci_add_cmd(pcr, WRITE_REG_CMD,
+ AUTOLOAD_CFG_BASE + 3, 0xB0, 0x80);
return rtsx_pci_send_cmd(pcr, 100);
}
@@ -129,15 +184,11 @@
static int rts5249_switch_output_voltage(struct rtsx_pcr *pcr, u8 voltage)
{
int err;
- u8 clk_drive, cmd_drive, dat_drive;
if (voltage == OUTPUT_3V3) {
err = rtsx_pci_write_phy_register(pcr, PHY_TUNE, 0x4FC0 | 0x24);
if (err < 0)
return err;
- clk_drive = 0x99;
- cmd_drive = 0x99;
- dat_drive = 0x92;
} else if (voltage == OUTPUT_1V8) {
err = rtsx_pci_write_phy_register(pcr, PHY_BACR, 0x3C02);
if (err < 0)
@@ -145,25 +196,18 @@
err = rtsx_pci_write_phy_register(pcr, PHY_TUNE, 0x4C40 | 0x24);
if (err < 0)
return err;
- clk_drive = 0xb3;
- cmd_drive = 0xb3;
- dat_drive = 0xb3;
} else {
return -EINVAL;
}
/* set pad drive */
rtsx_pci_init_cmd(pcr);
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_CLK_DRIVE_SEL,
- 0xFF, clk_drive);
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_CMD_DRIVE_SEL,
- 0xFF, cmd_drive);
- rtsx_pci_add_cmd(pcr, WRITE_REG_CMD, SD30_DAT_DRIVE_SEL,
- 0xFF, dat_drive);
+ rts5249_fill_driving(pcr, voltage);
return rtsx_pci_send_cmd(pcr, 100);
}
static const struct pcr_ops rts5249_pcr_ops = {
+ .fetch_vendor_settings = rts5249_fetch_vendor_settings,
.extra_init_hw = rts5249_extra_init_hw,
.optimize_phy = rts5249_optimize_phy,
.turn_on_led = rts5249_turn_on_led,
@@ -233,6 +277,12 @@
pcr->num_slots = 2;
pcr->ops = &rts5249_pcr_ops;
+ pcr->flags = 0;
+ pcr->card_drive_sel = RTSX_CARD_DRIVE_DEFAULT;
+ pcr->sd30_drive_sel_1v8 = CFG_DRIVER_TYPE_C;
+ pcr->sd30_drive_sel_3v3 = CFG_DRIVER_TYPE_B;
+ pcr->aspm_en = ASPM_L1_EN;
+
pcr->ic_version = rts5249_get_ic_version(pcr);
pcr->sd_pull_ctl_enable_tbl = rts5249_sd_pull_ctl_enable_tbl;
pcr->sd_pull_ctl_disable_tbl = rts5249_sd_pull_ctl_disable_tbl;