Blackfin: check SIC defines rather than variant names
Rather than having to maintain a hard coded list of Blackfin variants, use
the SIC defines themselves. This fixes build problems on BF51x/BF538 under
some configurations as they were missing from one of the lists.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/mach-common/ints-priority.c b/arch/blackfin/mach-common/ints-priority.c
index 6e80861..351afd0 100644
--- a/arch/blackfin/mach-common/ints-priority.c
+++ b/arch/blackfin/mach-common/ints-priority.c
@@ -1152,23 +1152,22 @@
} else {
struct ivgx *ivg = ivg7_13[vec - IVG7].ifirst;
struct ivgx *ivg_stop = ivg7_13[vec - IVG7].istop;
-#if defined(CONFIG_BF54x) || defined(CONFIG_BF52x) || defined(CONFIG_BF561) \
- || defined(BF538_FAMILY) || defined(CONFIG_BF51x)
+#if defined(SIC_ISR0) || defined(SICA_ISR0)
unsigned long sic_status[3];
if (smp_processor_id()) {
-#ifdef CONFIG_SMP
+# ifdef SICB_ISR0
/* This will be optimized out in UP mode. */
sic_status[0] = bfin_read_SICB_ISR0() & bfin_read_SICB_IMASK0();
sic_status[1] = bfin_read_SICB_ISR1() & bfin_read_SICB_IMASK1();
-#endif
+# endif
} else {
sic_status[0] = bfin_read_SIC_ISR0() & bfin_read_SIC_IMASK0();
sic_status[1] = bfin_read_SIC_ISR1() & bfin_read_SIC_IMASK1();
}
-#ifdef CONFIG_BF54x
+# ifdef SIC_ISR2
sic_status[2] = bfin_read_SIC_ISR2() & bfin_read_SIC_IMASK2();
-#endif
+# endif
for (;; ivg++) {
if (ivg >= ivg_stop) {
atomic_inc(&num_spurious);
@@ -1234,14 +1233,14 @@
irq = IRQ_CORETMR;
} else {
-#if defined(CONFIG_BF54x) || defined(CONFIG_BF52x) || defined(CONFIG_BF561)
+#if defined(SIC_ISR0) || defined(SICA_ISR0)
unsigned long sic_status[3];
sic_status[0] = bfin_read_SIC_ISR0() & bfin_read_SIC_IMASK0();
sic_status[1] = bfin_read_SIC_ISR1() & bfin_read_SIC_IMASK1();
-#ifdef CONFIG_BF54x
+# ifdef SIC_ISR2
sic_status[2] = bfin_read_SIC_ISR2() & bfin_read_SIC_IMASK2();
-#endif
+# endif
for (;; ivg++) {
if (ivg >= ivg_stop) {
atomic_inc(&num_spurious);