misc: Add Lattice ECP3 FPGA configuration via SPI
This patch adds support for bitstream configuration (programming /
loading) of the Lattice ECP3 FPGA's via the SPI bus.
Here an example on my custom MPC5200 based board:
$ echo 1 > /sys/class/firmware/spi0.0/loading
$ cat fpga_a4m2k.bit > /sys/class/firmware/spi0.0/data
$ echo 0 > /sys/class/firmware/spi0.0/loading
leads to these messages:
lattice-ecp3 spi0.0: FPGA Lattice ECP3-35 detected
lattice-ecp3 spi0.0: Configuring the FPGA...
lattice-ecp3 spi0.0: FPGA succesfully configured!
Signed-off-by: Stefan Roese <sr@denx.de>
Acked-by: Ming Lei <ming.lei@canonical.com>
Reviewed-by: Grant Likely <grant.likely@secretlab.ca>
Cc: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/misc/Makefile b/drivers/misc/Makefile
index 5c99726..35a1463 100644
--- a/drivers/misc/Makefile
+++ b/drivers/misc/Makefile
@@ -51,3 +51,4 @@
obj-$(CONFIG_INTEL_MEI) += mei/
obj-$(CONFIG_MAX8997_MUIC) += max8997-muic.o
obj-$(CONFIG_VMWARE_VMCI) += vmw_vmci/
+obj-$(CONFIG_LATTICE_ECP3_CONFIG) += lattice-ecp3-config.o