[SCSI] qla4xxx: Clear the RISC interrupt bit during FW init
This patch fix kernel panic during kdump.
Signed-off-by: Sarang Radke <sarang.radke@qlogic.com>
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Reviewed-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/qla4xxx/ql4_init.c b/drivers/scsi/qla4xxx/ql4_init.c
index 1bdfa81..90614f3 100644
--- a/drivers/scsi/qla4xxx/ql4_init.c
+++ b/drivers/scsi/qla4xxx/ql4_init.c
@@ -697,6 +697,9 @@
writel(set_rmask(CSR_SCSI_PROCESSOR_INTR),
&ha->reg->ctrl_status);
readl(&ha->reg->ctrl_status);
+ writel(set_rmask(CSR_SCSI_COMPLETION_INTR),
+ &ha->reg->ctrl_status);
+ readl(&ha->reg->ctrl_status);
spin_unlock_irqrestore(&ha->hardware_lock, flags);
if (qla4xxx_get_firmware_state(ha) == QLA_SUCCESS) {
DEBUG2(printk("scsi%ld: %s: Get firmware "