sctp: implement sctp association probing module

This patch implement sctp association probing module, the module
will be called sctp_probe.

This module allows for capturing the changes to SCTP association
state in response to incoming packets. It is used for debugging
SCTP congestion control algorithms.

Usage:
  $ modprobe sctp_probe [full=n] [port=n] [bufsize=n]
  $ cat /proc/net/sctpprobe

  The output format is:
    TIME     ASSOC     LPORT RPORT MTU    RWND  UNACK <REMOTE-ADDR   STATE  CWND   SSTHRESH  INFLIGHT  PARTIAL_BYTES_ACKED MTU> ...

  The output will be like this:
    9.226086 c4064c48  9000  8000  1500    53352     1 *192.168.0.19  1     4380    54784     1252        0     1500
    9.287195 c4064c48  9000  8000  1500    45144     5 *192.168.0.19  1     5880    54784     6500        0     1500
    9.289130 c4064c48  9000  8000  1500    42724     5 *192.168.0.19  1     7380    54784     6500        0     1500
    9.620332 c4064c48  9000  8000  1500    48284     4 *192.168.0.19  1     8880    54784     5200        0     1500
    ......

Signed-off-by: Wei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: Vlad Yasevich <vladislav.yasevich@hp.com>
diff --git a/net/sctp/Kconfig b/net/sctp/Kconfig
index 58b3e88..126b014 100644
--- a/net/sctp/Kconfig
+++ b/net/sctp/Kconfig
@@ -37,6 +37,18 @@
 
 if IP_SCTP
 
+config NET_SCTPPROBE
+	tristate "SCTP: Association probing"
+        depends on PROC_FS && KPROBES
+        ---help---
+        This module allows for capturing the changes to SCTP association
+        state in response to incoming packets. It is used for debugging
+        SCTP congestion control algorithms. If you don't understand
+        what was just said, you don't need it: say N.
+
+        To compile this code as a module, choose M here: the
+        module will be called sctp_probe.
+
 config SCTP_DBG_MSG
 	bool "SCTP: Debug messages"
 	help