powerpc/fsl-booke: Move loadcam_entry back to asm code to fix SMP ftrace
When we build with ftrace enabled its possible that loadcam_entry would
have used the stack pointer (even though the code doesn't need it). We
call loadcam_entry in __secondary_start before the stack is setup. To
ensure that loadcam_entry doesn't use the stack pointer the easiest
solution is to just have it in asm code.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/mm/tlb_nohash_low.S b/arch/powerpc/mm/tlb_nohash_low.S
index e925cb5..cfa7682 100644
--- a/arch/powerpc/mm/tlb_nohash_low.S
+++ b/arch/powerpc/mm/tlb_nohash_low.S
@@ -365,3 +365,31 @@
#else
#error Unsupported processor type !
#endif
+
+#if defined(CONFIG_FSL_BOOKE)
+/*
+ * extern void loadcam_entry(unsigned int index)
+ *
+ * Load TLBCAM[index] entry in to the L2 CAM MMU
+ */
+_GLOBAL(loadcam_entry)
+ LOAD_REG_ADDR(r4, TLBCAM)
+ mulli r5,r3,TLBCAM_SIZE
+ add r3,r5,r4
+ lwz r4,TLBCAM_MAS0(r3)
+ mtspr SPRN_MAS0,r4
+ lwz r4,TLBCAM_MAS1(r3)
+ mtspr SPRN_MAS1,r4
+ PPC_LL r4,TLBCAM_MAS2(r3)
+ mtspr SPRN_MAS2,r4
+ lwz r4,TLBCAM_MAS3(r3)
+ mtspr SPRN_MAS3,r4
+BEGIN_MMU_FTR_SECTION
+ lwz r4,TLBCAM_MAS7(r3)
+ mtspr SPRN_MAS7,r4
+END_MMU_FTR_SECTION_IFSET(MMU_FTR_BIG_PHYS)
+ isync
+ tlbwe
+ isync
+ blr
+#endif