[IPSEC]: Set skb->data to payload in x->mode->output
This patch changes the calling convention so that on entry from
x->mode->output and before entry into x->type->output skb->data
will point to the payload instead of the IP header.
This is essentially a redistribution of skb_push/skb_pull calls
with the aim of minimising them on the common path of tunnel +
ESP.
It'll also let us use the same calling convention between IPv4
and IPv6 with the next patch.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv4/esp4.c b/net/ipv4/esp4.c
index 1af332d..0f5e838 100644
--- a/net/ipv4/esp4.c
+++ b/net/ipv4/esp4.c
@@ -28,9 +28,7 @@
int alen;
int nfrags;
- /* Strip IP+ESP header. */
- __skb_pull(skb, skb_transport_offset(skb));
- /* Now skb is pure payload to encrypt */
+ /* skb is pure payload to encrypt */
err = -ENOMEM;
@@ -60,7 +58,7 @@
tail[clen - skb->len - 2] = (clen - skb->len) - 2;
pskb_put(skb, trailer, clen - skb->len);
- __skb_push(skb, -skb_network_offset(skb));
+ skb_push(skb, -skb_network_offset(skb));
top_iph = ip_hdr(skb);
esph = (struct ip_esp_hdr *)(skb_network_header(skb) +
top_iph->ihl * 4);