[IPSEC]: Set skb->data to payload in x->mode->output
This patch changes the calling convention so that on entry from
x->mode->output and before entry into x->type->output skb->data
will point to the payload instead of the IP header.
This is essentially a redistribution of skb_push/skb_pull calls
with the aim of minimising them on the common path of tunnel +
ESP.
It'll also let us use the same calling convention between IPv4
and IPv6 with the next patch.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv6/xfrm6_mode_ro.c b/net/ipv6/xfrm6_mode_ro.c
index 2575804..5c29b36 100644
--- a/net/ipv6/xfrm6_mode_ro.c
+++ b/net/ipv6/xfrm6_mode_ro.c
@@ -42,8 +42,8 @@
* filled in by x->type->output and the mac header will be set to the
* nextheader field of the extension header directly preceding the
* encapsulation header, or in its absence, that of the top IP header.
- * The value of skb->data and the network header will always point to the
- * top IP header.
+ * The value of the network header will always point to the top IP header
+ * while skb->data will point to the payload.
*/
static int xfrm6_ro_output(struct xfrm_state *x, struct sk_buff *skb)
{
@@ -51,14 +51,14 @@
u8 *prevhdr;
int hdr_len;
- skb_push(skb, x->props.header_len);
iph = ipv6_hdr(skb);
hdr_len = x->type->hdr_offset(x, skb, &prevhdr);
skb_set_mac_header(skb, (prevhdr - x->props.header_len) - skb->data);
- skb_reset_network_header(skb);
- skb_set_transport_header(skb, hdr_len);
- memmove(skb->data, iph, hdr_len);
+ skb_set_network_header(skb, -x->props.header_len);
+ skb_set_transport_header(skb, hdr_len - x->props.header_len);
+ __skb_pull(skb, hdr_len);
+ memmove(ipv6_hdr(skb), iph, hdr_len);
x->lastused = get_seconds();