(2.6.20) pata_mpiix: fix PIO setup issues
Fix clearing/setting the wrong TIME/IE/PPE bits for a slave drive caused by a
wrong shift count.
Fix the PIO mode 1 being overclocked by wrongly selecting the fast timing bank.
Also, fix/rephrase some comments while at it.
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/ata/pata_mpiix.c b/drivers/ata/pata_mpiix.c
index 976663d..4e97a7e 100644
--- a/drivers/ata/pata_mpiix.c
+++ b/drivers/ata/pata_mpiix.c
@@ -35,7 +35,7 @@
#include <linux/libata.h>
#define DRV_NAME "pata_mpiix"
-#define DRV_VERSION "0.7.3"
+#define DRV_VERSION "0.7.4"
enum {
IDETIM = 0x6C, /* IDE control register */
@@ -80,8 +80,8 @@
* @adev: ATA device
*
* Called to do the PIO mode setup. The MPIIX allows us to program the
- * IORDY sample point (2-5 clocks), recovery 1-4 clocks and whether
- * prefetching or iordy are used.
+ * IORDY sample point (2-5 clocks), recovery (1-4 clocks) and whether
+ * prefetching or IORDY are used.
*
* This would get very ugly because we can only program timing for one
* device at a time, the other gets PIO0. Fortunately libata calls
@@ -103,18 +103,19 @@
{ 2, 3 }, };
pci_read_config_word(pdev, IDETIM, &idetim);
- /* Mask the IORDY/TIME/PPE0 bank for this device */
+
+ /* Mask the IORDY/TIME/PPE for this device */
if (adev->class == ATA_DEV_ATA)
- control |= PPE; /* PPE enable for disk */
+ control |= PPE; /* Enable prefetch/posting for disk */
if (ata_pio_need_iordy(adev))
- control |= IORDY; /* IORDY */
- if (pio > 0)
+ control |= IORDY;
+ if (pio > 1)
control |= FTIM; /* This drive is on the fast timing bank */
/* Mask out timing and clear both TIME bank selects */
idetim &= 0xCCEE;
- idetim &= ~(0x07 << (2 * adev->devno));
- idetim |= (control << (2 * adev->devno));
+ idetim &= ~(0x07 << (4 * adev->devno));
+ idetim |= control << (4 * adev->devno);
idetim |= (timings[pio][0] << 12) | (timings[pio][1] << 8);
pci_write_config_word(pdev, IDETIM, idetim);