i2c: bcm2835: clear reserved bits in S-Register
The datasheet mentions on page 31 that the bits 10-31 must be read as
don't care and written as 0.
https://www.raspberrypi.org/wp-content/uploads/2012/02/BCM2835-ARM-Peripherals.pdf
We cannot guarantee that we read bits 10-31 as always 0 (because the
datasheet says read as don't care). We clear the bits with a bitmask to
prevent writing back unknown data at the reserved bits.
Signed-off-by: Silvan Wicki <linux_wi@tinag.ch>
Acked-by: Stephen Warren <swarren@wwwdotorg.org>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/drivers/i2c/busses/i2c-bcm2835.c b/drivers/i2c/busses/i2c-bcm2835.c
index c9336a3..aa06da1 100644
--- a/drivers/i2c/busses/i2c-bcm2835.c
+++ b/drivers/i2c/busses/i2c-bcm2835.c
@@ -50,6 +50,8 @@
#define BCM2835_I2C_S_CLKT BIT(9)
#define BCM2835_I2C_S_LEN BIT(10) /* Fake bit for SW error reporting */
+#define BCM2835_I2C_BITMSK_S 0x03FF
+
#define BCM2835_I2C_TIMEOUT (msecs_to_jiffies(1000))
struct bcm2835_i2c_dev {
@@ -111,6 +113,7 @@
u32 val, err;
val = bcm2835_i2c_readl(i2c_dev, BCM2835_I2C_S);
+ val &= BCM2835_I2C_BITMSK_S;
bcm2835_i2c_writel(i2c_dev, BCM2835_I2C_S, val);
err = val & (BCM2835_I2C_S_CLKT | BCM2835_I2C_S_ERR);