sh: sh7785lcr: fix I2C device address map for 32-bit mode
This fixes up the broken I2C offset in 32-bit mode.
The cause is because the board datasheet had a mistake.
Signed-off-by: Yoshihiro Shimoda <shimoda.yoshihiro@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/arch/sh/include/mach-common/mach/sh7785lcr.h b/arch/sh/include/mach-common/mach/sh7785lcr.h
index 1ce27d5..90011d4 100644
--- a/arch/sh/include/mach-common/mach/sh7785lcr.h
+++ b/arch/sh/include/mach-common/mach/sh7785lcr.h
@@ -9,11 +9,11 @@
* -----------------------------+---------------+---------------
* 0x00000000 - 0x03ffffff(CS0) | NOR Flash | NOR Flash
* 0x04000000 - 0x05ffffff(CS1) | PLD | PLD
- * 0x06000000 - 0x07ffffff(CS1) | reserved | I2C
+ * 0x06000000 - 0x07ffffff(CS1) | I2C | I2C
* 0x08000000 - 0x0bffffff(CS2) | USB | DDR SDRAM
* 0x0c000000 - 0x0fffffff(CS3) | SD | DDR SDRAM
* 0x10000000 - 0x13ffffff(CS4) | SM107 | SM107
- * 0x14000000 - 0x17ffffff(CS5) | I2C | USB
+ * 0x14000000 - 0x17ffffff(CS5) | reserved | USB
* 0x18000000 - 0x1bffffff(CS6) | reserved | SD
* 0x40000000 - 0x5fffffff | DDR SDRAM | (cannot use)
*
@@ -32,6 +32,9 @@
#define PLD_VERSR (PLD_BASE_ADDR + 0x0c)
#define PLD_MMSR (PLD_BASE_ADDR + 0x0e)
+#define PCA9564_ADDR 0x06000000 /* I2C */
+#define PCA9564_SIZE 0x00000100
+
#define SM107_MEM_ADDR 0x10000000
#define SM107_MEM_SIZE 0x00e00000
#define SM107_REG_ADDR 0x13e00000
@@ -40,16 +43,13 @@
#if defined(CONFIG_SH_SH7785LCR_29BIT_PHYSMAPS)
#define R8A66597_ADDR 0x14000000 /* USB */
#define CG200_ADDR 0x18000000 /* SD */
-#define PCA9564_ADDR 0x06000000 /* I2C */
#else
#define R8A66597_ADDR 0x08000000
#define CG200_ADDR 0x0c000000
-#define PCA9564_ADDR 0x14000000
#endif
#define R8A66597_SIZE 0x00000100
#define CG200_SIZE 0x00010000
-#define PCA9564_SIZE 0x00000100
#endif /* __ASM_SH_RENESAS_SH7785LCR_H */