ixgbe: Fix ethtool output with advertised mode.
Ethtool tries to get advertised speed from phy.autoneg_advertised.
However for copper media this wasn't happening until later do to
an other fix which moved mac.ops.setup_link_speed placement in
ixgbe_link_config(). This patch will display the default advertised
speeds if it can't yet get this information from phy.autoneg_advertised.
Signed-off-by: Don Skidmore <donald.c.skidmore@intel.com>
Acked-by: Mallikarjuna R Chilakala <mallikarjuna.chilakala@intel.com>
Acked-by: Peter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ixgbe/ixgbe_ethtool.c b/drivers/net/ixgbe/ixgbe_ethtool.c
index 18ecba7..34b4a84 100644
--- a/drivers/net/ixgbe/ixgbe_ethtool.c
+++ b/drivers/net/ixgbe/ixgbe_ethtool.c
@@ -129,6 +129,15 @@
ecmd->advertising |= ADVERTISED_10000baseT_Full;
if (hw->phy.autoneg_advertised & IXGBE_LINK_SPEED_1GB_FULL)
ecmd->advertising |= ADVERTISED_1000baseT_Full;
+ /*
+ * It's possible that phy.autoneg_advertised may not be
+ * set yet. If so display what the default would be -
+ * both 1G and 10G supported.
+ */
+ if (!(ecmd->advertising & (ADVERTISED_1000baseT_Full |
+ ADVERTISED_10000baseT_Full)))
+ ecmd->advertising |= (ADVERTISED_10000baseT_Full |
+ ADVERTISED_1000baseT_Full);
ecmd->port = PORT_TP;
} else if (hw->phy.media_type == ixgbe_media_type_backplane) {