[SCSI] pm80xx: Resetting the phy state.
Setting the phy state for hard reset response.
After sending hard reset for a device ,phy down event sets
the phy state to zero but for phy up event it will not set
the phy state again.This will cause problem to successive
hard resets.
Signed-off-by: Nikith.Ganigarakoppal@pmcs.com
Signed-off-by: Anandkumar.Santhanam@pmcs.com
Reviewed-by: Jack Wang <jinpu.wang@profitbricks.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/pm8001/pm8001_hwi.c b/drivers/scsi/pm8001/pm8001_hwi.c
index f16ece9..0a1296a 100644
--- a/drivers/scsi/pm8001/pm8001_hwi.c
+++ b/drivers/scsi/pm8001/pm8001_hwi.c
@@ -3403,6 +3403,7 @@
unsigned long flags;
u8 deviceType = pPayload->sas_identify.dev_type;
port->port_state = portstate;
+ phy->phy_state = PHY_STATE_LINK_UP_SPC;
PM8001_MSG_DBG(pm8001_ha,
pm8001_printk("HW_EVENT_SAS_PHY_UP port id = %d, phy id = %d\n",
port_id, phy_id));
@@ -3483,6 +3484,7 @@
pm8001_printk("HW_EVENT_SATA_PHY_UP port id = %d,"
" phy id = %d\n", port_id, phy_id));
port->port_state = portstate;
+ phy->phy_state = PHY_STATE_LINK_UP_SPC;
port->port_attached = 1;
pm8001_get_lrate_mode(phy, link_rate);
phy->phy_type |= PORT_TYPE_SATA;