| MIPS Global Interrupt Controller (GIC) |
| |
| The MIPS GIC routes external interrupts to individual VPEs and IRQ pins. |
| It also supports local (per-processor) interrupts and software-generated |
| interrupts which can be used as IPIs. The GIC also includes a free-running |
| global timer, per-CPU count/compare timers, and a watchdog. |
| |
| Required properties: |
| - compatible : Should be "mti,gic". |
| - interrupt-controller : Identifies the node as an interrupt controller |
| - #interrupt-cells : Specifies the number of cells needed to encode an |
| interrupt specifier. Should be 3. |
| - The first cell is the type of interrupt, local or shared. |
| See <include/dt-bindings/interrupt-controller/mips-gic.h>. |
| - The second cell is the GIC interrupt number. |
| - The third cell encodes the interrupt flags. |
| See <include/dt-bindings/interrupt-controller/irq.h> for a list of valid |
| flags. |
| |
| Optional properties: |
| - reg : Base address and length of the GIC registers. If not present, |
| the base address reported by the hardware GCR_GIC_BASE will be used. |
| - mti,reserved-cpu-vectors : Specifies the list of CPU interrupt vectors |
| to which the GIC may not route interrupts. Valid values are 2 - 7. |
| This property is ignored if the CPU is started in EIC mode. |
| |
| Required properties for timer sub-node: |
| - compatible : Should be "mti,gic-timer". |
| - interrupts : Interrupt for the GIC local timer. |
| |
| Optional properties for timer sub-node: |
| - clocks : GIC timer operating clock. |
| - clock-frequency : Clock frequency at which the GIC timers operate. |
| |
| Note that one of clocks or clock-frequency must be specified. |
| |
| Example: |
| |
| gic: interrupt-controller@1bdc0000 { |
| compatible = "mti,gic"; |
| reg = <0x1bdc0000 0x20000>; |
| |
| interrupt-controller; |
| #interrupt-cells = <3>; |
| |
| mti,reserved-cpu-vectors = <7>; |
| |
| timer { |
| compatible = "mti,gic-timer"; |
| interrupts = <GIC_LOCAL 1 IRQ_TYPE_NONE>; |
| clock-frequency = <50000000>; |
| }; |
| }; |
| |
| uart@18101400 { |
| ... |
| interrupt-parent = <&gic>; |
| interrupts = <GIC_SHARED 24 IRQ_TYPE_LEVEL_HIGH>; |
| ... |
| }; |