apne: convert to net_device_ops
Yet another driver.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/apne.c b/drivers/net/apne.c
index 7426f69..1437f5d 100644
--- a/drivers/net/apne.c
+++ b/drivers/net/apne.c
@@ -78,9 +78,6 @@
struct net_device * __init apne_probe(int unit);
static int apne_probe1(struct net_device *dev, int ioaddr);
-static int apne_open(struct net_device *dev);
-static int apne_close(struct net_device *dev);
-
static void apne_reset_8390(struct net_device *dev);
static void apne_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr,
int ring_page);
@@ -314,6 +311,7 @@
dev->base_addr = ioaddr;
dev->irq = IRQ_AMIGA_PORTS;
+ dev->netdev_ops = &ei_netdev_ops;
/* Install the Interrupt handler */
i = request_irq(dev->irq, apne_interrupt, IRQF_SHARED, DRV_NAME, dev);
@@ -337,11 +335,7 @@
ei_status.block_input = &apne_block_input;
ei_status.block_output = &apne_block_output;
ei_status.get_8390_hdr = &apne_get_8390_hdr;
- dev->open = &apne_open;
- dev->stop = &apne_close;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = ei_poll;
-#endif
+
NS8390_init(dev, 0);
pcmcia_ack_int(pcmcia_get_intreq()); /* ack PCMCIA int req */
@@ -352,22 +346,6 @@
return 0;
}
-static int
-apne_open(struct net_device *dev)
-{
- ei_open(dev);
- return 0;
-}
-
-static int
-apne_close(struct net_device *dev)
-{
- if (ei_debug > 1)
- printk("%s: Shutting down ethercard.\n", dev->name);
- ei_close(dev);
- return 0;
-}
-
/* Hard reset the card. This used to pause for the same period that a
8390 reset command required, but that shouldn't be necessary. */
static void