[SCSI] qla2xxx: Re-register FDMI information after a LIP.
Original code would (incorrectly) only re-register after a
loop-down condition. Also, FDMI registration should be enabled
by default.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>
diff --git a/drivers/scsi/qla2xxx/qla_isr.c b/drivers/scsi/qla2xxx/qla_isr.c
index 285479b..5d9a64a 100644
--- a/drivers/scsi/qla2xxx/qla_isr.c
+++ b/drivers/scsi/qla2xxx/qla_isr.c
@@ -409,6 +409,7 @@
}
set_bit(REGISTER_FC4_NEEDED, &ha->dpc_flags);
+ set_bit(REGISTER_FDMI_NEEDED, &ha->dpc_flags);
ha->flags.management_server_logged_in = 0;
qla2x00_post_aen_work(ha, FCH_EVT_LIP, mb[1]);
@@ -454,8 +455,6 @@
ha->flags.management_server_logged_in = 0;
ha->link_data_rate = PORT_SPEED_UNKNOWN;
- if (ql2xfdmienable)
- set_bit(REGISTER_FDMI_NEEDED, &ha->dpc_flags);
qla2x00_post_aen_work(ha, FCH_EVT_LINKDOWN, 0);
break;
@@ -511,6 +510,7 @@
set_bit(RESET_MARKER_NEEDED, &ha->dpc_flags);
}
set_bit(REGISTER_FC4_NEEDED, &ha->dpc_flags);
+ set_bit(REGISTER_FDMI_NEEDED, &ha->dpc_flags);
ha->flags.gpsc_supported = 1;
ha->flags.management_server_logged_in = 0;