ARM: at91: move at91_init_leds to board init
This will also allow to finally move the gpio driver to platform device/driver.
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-ecbat91.c b/arch/arm/mach-at91/board-ecbat91.c
index 2510825..89cc372 100644
--- a/arch/arm/mach-at91/board-ecbat91.c
+++ b/arch/arm/mach-at91/board-ecbat91.c
@@ -50,9 +50,6 @@
/* Initialize processor: 18.432 MHz crystal */
at91_initialize(18432000);
-
- /* Setup the LEDs */
- at91_init_leds(AT91_PIN_PC7, AT91_PIN_PC7);
}
static struct macb_platform_data __initdata ecb_at91eth_data = {
@@ -142,6 +139,9 @@
static void __init ecb_at91board_init(void)
{
+ /* Setup the LEDs */
+ at91_init_leds(AT91_PIN_PC7, AT91_PIN_PC7);
+
/* Serial */
/* DBGU on ttyS0. (Rx & Tx only) */
at91_register_uart(0, 0, 0);