[SCSI] aacraid: cleanup and version stamp driver
There is some residual cleanup of the last series of patches and the
need to bump the revision number to draw the line in the sand.
The cmd->SCp.phase is set in the aac_valid_context routine, then set
again to the same value following it's return. The cmd->scsi_done is set
twice in the aac_queuecommand routine. Free up the scsidev FILO in
aac_probe_container as it is not needed further down the function in any
case. Improve the efficiency of the abort handler kernel print
parameters. Bump revision number of driver to approximate the equivalent
in the Adaptec supplied version.
Signed-off-by: Mark Salyzyn <aacraid@adaptec.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/aacraid/linit.c b/drivers/scsi/aacraid/linit.c
index 3cf3f64..a5950c1 100644
--- a/drivers/scsi/aacraid/linit.c
+++ b/drivers/scsi/aacraid/linit.c
@@ -260,7 +260,6 @@
(cmd->SCp.phase == AAC_OWNER_FIRMWARE))
return 0; /* Already owned by Adapter */
}
- cmd->scsi_done = done;
cmd->SCp.phase = AAC_OWNER_LOWLEVEL;
return (aac_scsi_cmd(cmd) ? FAILED : 0);
}
@@ -461,15 +460,15 @@
static int aac_eh_abort(struct scsi_cmnd* cmd)
{
- struct Scsi_Host * host = cmd->device->host;
+ struct scsi_device * dev = cmd->device;
+ struct Scsi_Host * host = dev->host;
struct aac_dev * aac = (struct aac_dev *)host->hostdata;
int count;
int ret = FAILED;
printk(KERN_ERR "%s: Host adapter abort request (%d,%d,%d,%d)\n",
AAC_DRIVERNAME,
- cmd->device->host->host_no, sdev_channel(cmd->device),
- sdev_id(cmd->device), cmd->device->lun);
+ host->host_no, sdev_channel(dev), sdev_id(dev), dev->lun);
switch (cmd->cmnd[0]) {
case SERVICE_ACTION_IN:
if (!(aac->raw_io_interface) ||