arcnet: Move EXPORT_SYMBOL after declarations
Use the normal kernel style for EXPORT_SYMBOL.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
diff --git a/drivers/net/arcnet/arcnet.c b/drivers/net/arcnet/arcnet.c
index 2be8ab6..a9535ec 100644
--- a/drivers/net/arcnet/arcnet.c
+++ b/drivers/net/arcnet/arcnet.c
@@ -68,8 +68,17 @@
* arc_proto_default instead. It also must not be NULL; if you would like
* to set it to NULL, set it to &arc_proto_null instead.
*/
-struct ArcProto *arc_proto_map[256], *arc_proto_default,
- *arc_bcast_proto, *arc_raw_proto;
+struct ArcProto *arc_proto_map[256];
+EXPORT_SYMBOL(arc_proto_map);
+
+struct ArcProto *arc_proto_default;
+EXPORT_SYMBOL(arc_proto_default);
+
+struct ArcProto *arc_bcast_proto;
+EXPORT_SYMBOL(arc_bcast_proto);
+
+struct ArcProto *arc_raw_proto;
+EXPORT_SYMBOL(arc_raw_proto);
static struct ArcProto arc_proto_null = {
.suffix = '?',
@@ -84,19 +93,7 @@
/* Exported function prototypes */
int arcnet_debug = ARCNET_DEBUG;
-
-EXPORT_SYMBOL(arc_proto_map);
-EXPORT_SYMBOL(arc_proto_default);
-EXPORT_SYMBOL(arc_bcast_proto);
-EXPORT_SYMBOL(arc_raw_proto);
-EXPORT_SYMBOL(arcnet_unregister_proto);
EXPORT_SYMBOL(arcnet_debug);
-EXPORT_SYMBOL(alloc_arcdev);
-EXPORT_SYMBOL(arcnet_interrupt);
-EXPORT_SYMBOL(arcnet_open);
-EXPORT_SYMBOL(arcnet_close);
-EXPORT_SYMBOL(arcnet_send_packet);
-EXPORT_SYMBOL(arcnet_timeout);
/* Internal function prototypes */
static int arcnet_header(struct sk_buff *skb, struct net_device *dev,
@@ -151,7 +148,6 @@
print_hex_dump(KERN_DEBUG, hdr, DUMP_PREFIX_OFFSET,
16, 1, skb->data, skb->len, true);
}
-
EXPORT_SYMBOL(arcnet_dump_skb);
#endif
@@ -211,6 +207,7 @@
arc_proto_map[count] = arc_proto_default;
}
}
+EXPORT_SYMBOL(arcnet_unregister_proto);
/* Add a buffer to the queue. Only the interrupt handler is allowed to do
* this, unless interrupts are disabled.
@@ -330,6 +327,7 @@
return dev;
}
+EXPORT_SYMBOL(alloc_arcdev);
/* Open/initialize the board. This is called sometime after booting when
* the 'ifconfig' program is run.
@@ -431,6 +429,7 @@
module_put(lp->hw.owner);
return error;
}
+EXPORT_SYMBOL(arcnet_open);
/* The inverse routine to arcnet_open - shuts down the card. */
int arcnet_close(struct net_device *dev)
@@ -450,6 +449,7 @@
module_put(lp->hw.owner);
return 0;
}
+EXPORT_SYMBOL(arcnet_close);
static int arcnet_header(struct sk_buff *skb, struct net_device *dev,
unsigned short type, const void *daddr,
@@ -592,6 +592,7 @@
return retval; /* no need to try again */
}
+EXPORT_SYMBOL(arcnet_send_packet);
/* Actually start transmitting a packet that was loaded into a buffer
* by prepare_tx. This should _only_ be called by the interrupt handler.
@@ -659,6 +660,7 @@
if (lp->cur_tx == -1)
netif_wake_queue(dev);
}
+EXPORT_SYMBOL(arcnet_timeout);
/* The typical workload of the driver: Handle the network interface
* interrupts. Establish which device needs attention, and call the correct
@@ -902,6 +904,7 @@
spin_unlock(&lp->lock);
return retval;
}
+EXPORT_SYMBOL(arcnet_interrupt);
/* This is a generic packet receiver that calls arcnet??_rx depending on the
* protocol ID found.