gpio/davinci: fix enabling unbanked GPIO IRQs
Unbanked GPIO IRQ handling code made a copy of just
the irq_chip structure for GPIO IRQ lines which caused
problems after the generic IRQ chip conversion because
there was no valid irq_chip_type structure with the
right "regs" populated. irq_gc_mask_set_bit() was
therefore accessing random addresses.
Fix it by making a copy of irq_chip_type structure
instead. This will ensure sane register offsets.
Cc: <stable@vger.kernel.org> # v3.0.x+
Reported-by: Jon Povey <Jon.Povey@racelogic.co.uk>
Tested-by: Jon Povey <Jon.Povey@racelogic.co.uk>
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/gpio/gpio-davinci.c b/drivers/gpio/gpio-davinci.c
index a6777e5..3d00016 100644
--- a/drivers/gpio/gpio-davinci.c
+++ b/drivers/gpio/gpio-davinci.c
@@ -386,7 +386,7 @@
* IRQ mux conflicts; gpio_irq_type_unbanked() is only for GPIOs.
*/
if (soc_info->gpio_unbanked) {
- static struct irq_chip gpio_irqchip_unbanked;
+ static struct irq_chip_type gpio_unbanked;
/* pass "bank 0" GPIO IRQs to AINTC */
chips[0].chip.to_irq = gpio_to_irq_unbanked;
@@ -394,9 +394,10 @@
/* AINTC handles mask/unmask; GPIO handles triggering */
irq = bank_irq;
- gpio_irqchip_unbanked = *irq_get_chip(irq);
- gpio_irqchip_unbanked.name = "GPIO-AINTC";
- gpio_irqchip_unbanked.irq_set_type = gpio_irq_type_unbanked;
+ gpio_unbanked = *container_of(irq_get_chip(irq),
+ struct irq_chip_type, chip);
+ gpio_unbanked.chip.name = "GPIO-AINTC";
+ gpio_unbanked.chip.irq_set_type = gpio_irq_type_unbanked;
/* default trigger: both edges */
g = gpio2regs(0);
@@ -405,7 +406,7 @@
/* set the direct IRQs up to use that irqchip */
for (gpio = 0; gpio < soc_info->gpio_unbanked; gpio++, irq++) {
- irq_set_chip(irq, &gpio_irqchip_unbanked);
+ irq_set_chip(irq, &gpio_unbanked.chip);
irq_set_handler_data(irq, &chips[gpio / 32]);
irq_set_status_flags(irq, IRQ_TYPE_EDGE_BOTH);
}