atlx: convert to net_device_ops
Convert this driver to network device ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/atlx/atl1.c b/drivers/net/atlx/atl1.c
index 611a86e..7a0fb04 100644
--- a/drivers/net/atlx/atl1.c
+++ b/drivers/net/atlx/atl1.c
@@ -2880,6 +2880,21 @@
}
#endif
+static const struct net_device_ops atl1_netdev_ops = {
+ .ndo_open = atl1_open,
+ .ndo_stop = atl1_close,
+ .ndo_set_multicast_list = atlx_set_multi,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = atl1_set_mac,
+ .ndo_change_mtu = atl1_change_mtu,
+ .ndo_do_ioctl = atlx_ioctl,
+ .ndo_tx_timeout = atlx_tx_timeout,
+ .ndo_vlan_rx_register = atlx_vlan_rx_register,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = atl1_poll_controller,
+#endif
+};
+
/*
* atl1_probe - Device Initialization Routine
* @pdev: PCI device information struct
@@ -2967,20 +2982,9 @@
adapter->mii.phy_id_mask = 0x1f;
adapter->mii.reg_num_mask = 0x1f;
- netdev->open = &atl1_open;
- netdev->stop = &atl1_close;
+ netdev->netdev_ops = &atl1_netdev_ops;
netdev->hard_start_xmit = &atl1_xmit_frame;
-
- netdev->set_multicast_list = &atlx_set_multi;
- netdev->set_mac_address = &atl1_set_mac;
- netdev->change_mtu = &atl1_change_mtu;
- netdev->do_ioctl = &atlx_ioctl;
- netdev->tx_timeout = &atlx_tx_timeout;
netdev->watchdog_timeo = 5 * HZ;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- netdev->poll_controller = atl1_poll_controller;
-#endif
- netdev->vlan_rx_register = atlx_vlan_rx_register;
netdev->ethtool_ops = &atl1_ethtool_ops;
adapter->bd_number = cards_found;