atlx: convert to net_device_ops
Convert this driver to network device ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/atlx/atl2.c b/drivers/net/atlx/atl2.c
index 60c9e53..688c21e 100644
--- a/drivers/net/atlx/atl2.c
+++ b/drivers/net/atlx/atl2.c
@@ -1311,6 +1311,22 @@
}
#endif
+
+static const struct net_device_ops atl2_netdev_ops = {
+ .ndo_open = atl2_open,
+ .ndo_stop = atl2_close,
+ .ndo_set_multicast_list = atl2_set_multi,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = atl2_set_mac,
+ .ndo_change_mtu = atl2_change_mtu,
+ .ndo_do_ioctl = atl2_ioctl,
+ .ndo_tx_timeout = atl2_tx_timeout,
+ .ndo_vlan_rx_register = atl2_vlan_rx_register,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = atl2_poll_controller,
+#endif
+};
+
/*
* atl2_probe - Device Initialization Routine
* @pdev: PCI device information struct
@@ -1384,25 +1400,10 @@
atl2_setup_pcicmd(pdev);
- netdev->open = &atl2_open;
- netdev->stop = &atl2_close;
netdev->hard_start_xmit = &atl2_xmit_frame;
- netdev->set_multicast_list = &atl2_set_multi;
- netdev->set_mac_address = &atl2_set_mac;
- netdev->change_mtu = &atl2_change_mtu;
- netdev->do_ioctl = &atl2_ioctl;
+ netdev->netdev_ops = &atl2_netdev_ops;
atl2_set_ethtool_ops(netdev);
-
-#ifdef CONFIG_NET_POLL_CONTROLLER
- netdev->poll_controller = atl2_poll_controller;
-#endif
-#ifdef HAVE_TX_TIMEOUT
- netdev->tx_timeout = &atl2_tx_timeout;
netdev->watchdog_timeo = 5 * HZ;
-#endif
-#ifdef NETIF_F_HW_VLAN_TX
- netdev->vlan_rx_register = atl2_vlan_rx_register;
-#endif
strncpy(netdev->name, pci_name(pdev), sizeof(netdev->name) - 1);
netdev->mem_start = mmio_start;