ath9k: Add helper to get ath9k specific current channel
Signed-off-by: Vasanthakumar Thiagarajan <vasanth@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index f7baa40..89bf07e 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -231,6 +231,19 @@
}
}
+static struct ath9k_channel *ath_get_curchannel(struct ath_softc *sc,
+ struct ieee80211_hw *hw)
+{
+ struct ieee80211_channel *curchan = hw->conf.channel;
+ struct ath9k_channel *channel;
+ u8 chan_idx;
+
+ chan_idx = curchan->hw_value;
+ channel = &sc->sc_ah->channels[chan_idx];
+ ath9k_update_ichannel(sc, hw, channel);
+ return channel;
+}
+
/*
* Set/change channels. If the channel is really being changed, it's done
* by reseting the chip. To accomplish this we must first cleanup any pending
@@ -1920,7 +1933,7 @@
struct ath_softc *sc = aphy->sc;
struct ieee80211_channel *curchan = hw->conf.channel;
struct ath9k_channel *init_channel;
- int r, pos;
+ int r;
DPRINTF(sc, ATH_DBG_CONFIG, "Starting driver with "
"initial channel: %d MHz\n", curchan->center_freq);
@@ -1950,11 +1963,9 @@
/* setup initial channel */
- pos = curchan->hw_value;
+ sc->chan_idx = curchan->hw_value;
- sc->chan_idx = pos;
- init_channel = &sc->sc_ah->channels[pos];
- ath9k_update_ichannel(sc, hw, init_channel);
+ init_channel = ath_get_curchannel(sc, hw);
/* Reset SERDES registers */
ath9k_hw_configpcipowersave(sc->sc_ah, 0);