bnx2x: add fan failure event handling
Shut down the device in case of fan failure to prevent HW damage.
Signed-off-by: Dmitry Kravkov <dmitry@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
index 967c41b..33ff60d 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
@@ -3299,6 +3299,17 @@
netdev_err(bp->dev, "Fan Failure on Network Controller has caused"
" the driver to shutdown the card to prevent permanent"
" damage. Please contact OEM Support for assistance\n");
+
+ /*
+ * Scheudle device reset (unload)
+ * This is due to some boards consuming sufficient power when driver is
+ * up to overheat if fan fails.
+ */
+ smp_mb__before_clear_bit();
+ set_bit(BNX2X_SP_RTNL_FAN_FAILURE, &bp->sp_rtnl_state);
+ smp_mb__after_clear_bit();
+ schedule_delayed_work(&bp->sp_rtnl_task, 0);
+
}
static inline void bnx2x_attn_int_deasserted0(struct bnx2x *bp, u32 attn)
@@ -8503,6 +8514,17 @@
if (test_and_clear_bit(BNX2X_SP_RTNL_SETUP_TC, &bp->sp_rtnl_state))
bnx2x_setup_tc(bp->dev, bp->dcbx_port_params.ets.num_of_cos);
+ /*
+ * in case of fan failure we need to reset id if the "stop on error"
+ * debug flag is set, since we trying to prevent permanent overheating
+ * damage
+ */
+ if (test_and_clear_bit(BNX2X_SP_RTNL_FAN_FAILURE, &bp->sp_rtnl_state)) {
+ DP(BNX2X_MSG_SP, "fan failure detected. Unloading driver");
+ netif_device_detach(bp->dev);
+ bnx2x_close(bp->dev);
+ }
+
sp_rtnl_exit:
rtnl_unlock();
}
@@ -9969,7 +9991,7 @@
}
/* called with rtnl_lock */
-static int bnx2x_close(struct net_device *dev)
+int bnx2x_close(struct net_device *dev)
{
struct bnx2x *bp = netdev_priv(dev);