Blackfin Serial Driver: handle anomaly 05000231
05000231 - UART STB Bit Incorrectly Affects Receiver Setting
For processors affected by this, we cannot safely allow CSTOPB to be set
as the UART will then be unable to properly clock in bytes.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/serial/bfin_5xx.c b/drivers/serial/bfin_5xx.c
index ab583ef..64603f5 100644
--- a/drivers/serial/bfin_5xx.c
+++ b/drivers/serial/bfin_5xx.c
@@ -828,8 +828,16 @@
__func__);
}
- if (termios->c_cflag & CSTOPB)
- lcr |= STB;
+ /* Anomaly notes:
+ * 05000231 - STOP bit is always set to 1 whatever the user is set.
+ */
+ if (termios->c_cflag & CSTOPB) {
+ if (ANOMALY_05000231)
+ printk(KERN_WARNING "STOP bits other than 1 is not "
+ "supported in case of anomaly 05000231.\n");
+ else
+ lcr |= STB;
+ }
if (termios->c_cflag & PARENB)
lcr |= PEN;
if (!(termios->c_cflag & PARODD))