mwifiex: make use of is_zero_ether_addr()
Use is_zero_ether_addr() instead of directly using memcmp() to
determine if the ethernet address is all zeros.
Cc: Wei Yongjun <yongjun_wei@trendmicro.com.cn>
Signed-off-by: Bing Zhao <bzhao@marvell.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/mwifiex/scan.c b/drivers/net/wireless/mwifiex/scan.c
index 215d07e6..9e077e5 100644
--- a/drivers/net/wireless/mwifiex/scan.c
+++ b/drivers/net/wireless/mwifiex/scan.c
@@ -726,7 +726,6 @@
struct mwifiex_ie_types_num_probes *num_probes_tlv;
struct mwifiex_ie_types_wildcard_ssid_params *wildcard_ssid_tlv;
struct mwifiex_ie_types_rates_param_set *rates_tlv;
- const u8 zero_mac[ETH_ALEN] = { 0, 0, 0, 0, 0, 0 };
u8 *tlv_pos;
u32 num_probes;
u32 ssid_len;
@@ -840,8 +839,7 @@
* or BSSID filter applied to the scan results in the firmware.
*/
if ((i && ssid_filter) ||
- memcmp(scan_cfg_out->specific_bssid, &zero_mac,
- sizeof(zero_mac)))
+ !is_zero_ether_addr(scan_cfg_out->specific_bssid))
*filtered_scan = true;
} else {
scan_cfg_out->bss_mode = (u8) adapter->scan_mode;