ath10k: add spectral scan feature
Adds the spectral scan feature for ath10k. The spectral scan is triggered by
configuring a mode through a debugfs control file. Samples can be gathered via
another relay debugfs file.
Essentially, to try it out:
ip link set dev wlan0 up
echo background > /sys/kernel/debug/ieee80211/phy0/ath10k/spectral_scan_ctl
echo trigger > /sys/kernel/debug/ieee80211/phy0/ath10k/spectral_scan_ctl
iw dev wlan0 scan
echo disable > /sys/kernel/debug/ieee80211/phy0/ath10k/spectral_scan_ctl
cat /sys/kernel/debug/ieee80211/phy0/ath10k/spectral_scan0 > samples
This feature is still experimental. Based on the original RFC patch of
Sven Eckelmann.
Signed-off-by: Simon Wunderlich <sw@simonwunderlich.de>
Signed-off-by: Mathias Kretschmer <mathias.kretschmer@fokus.fraunhofer.de>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/core.h b/drivers/net/wireless/ath/ath10k/core.h
index ded3af2..d5c95d4 100644
--- a/drivers/net/wireless/ath/ath10k/core.h
+++ b/drivers/net/wireless/ath/ath10k/core.h
@@ -31,6 +31,7 @@
#include "../ath.h"
#include "../regd.h"
#include "../dfs_pattern_detector.h"
+#include "spectral.h"
#define MS(_v, _f) (((_v) & _f##_MASK) >> _f##_LSB)
#define SM(_v, _f) (((_v) << _f##_LSB) & _f##_MASK)
@@ -237,6 +238,7 @@
bool is_started;
bool is_up;
+ bool spectral_enabled;
u32 aid;
u8 bssid[ETH_ALEN];
@@ -499,6 +501,15 @@
#ifdef CONFIG_ATH10K_DEBUGFS
struct ath10k_debug debug;
#endif
+
+ struct {
+ /* relay(fs) channel for spectral scan */
+ struct rchan *rfs_chan_spec_scan;
+
+ /* spectral_mode and spec_config are protected by conf_mutex */
+ enum ath10k_spectral_mode mode;
+ struct ath10k_spec_scan config;
+ } spectral;
};
struct ath10k *ath10k_core_create(void *hif_priv, struct device *dev,