[PATCH] Unlinline a bunch of other functions
Remove the "inline" keyword from a bunch of big functions in the kernel with
the goal of shrinking it by 30kb to 40kb
Signed-off-by: Arjan van de Ven <arjan@infradead.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Acked-by: Jeff Garzik <jgarzik@pobox.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/net/wireless/wavelan.c b/drivers/net/wireless/wavelan.c
index b0d8b5b..ff192e9 100644
--- a/drivers/net/wireless/wavelan.c
+++ b/drivers/net/wireless/wavelan.c
@@ -102,7 +102,7 @@
* Write to card's Host Adapter Command Register. Include a delay for
* those times when it is needed.
*/
-static inline void hacr_write_slow(unsigned long ioaddr, u16 hacr)
+static void hacr_write_slow(unsigned long ioaddr, u16 hacr)
{
hacr_write(ioaddr, hacr);
/* delay might only be needed sometimes */
@@ -242,7 +242,7 @@
* The Windows drivers don't use the CRC, but the AP and the PtP tool
* depend on it.
*/
-static inline u16 psa_crc(u8 * psa, /* The PSA */
+static u16 psa_crc(u8 * psa, /* The PSA */
int size)
{ /* Number of short for CRC */
int byte_cnt; /* Loop on the PSA */
@@ -310,7 +310,7 @@
/*
* Write 1 byte to the MMC.
*/
-static inline void mmc_out(unsigned long ioaddr, u16 o, u8 d)
+static void mmc_out(unsigned long ioaddr, u16 o, u8 d)
{
int count = 0;
@@ -326,7 +326,7 @@
* Routine to write bytes to the Modem Management Controller.
* We start at the end because it is the way it should be!
*/
-static inline void mmc_write(unsigned long ioaddr, u8 o, u8 * b, int n)
+static void mmc_write(unsigned long ioaddr, u8 o, u8 * b, int n)
{
o += n;
b += n;
@@ -340,7 +340,7 @@
* Read a byte from the MMC.
* Optimised version for 1 byte, avoid using memory.
*/
-static inline u8 mmc_in(unsigned long ioaddr, u16 o)
+static u8 mmc_in(unsigned long ioaddr, u16 o)
{
int count = 0;
@@ -587,7 +587,7 @@
* Set channel attention bit and busy wait until command has
* completed, then acknowledge completion of the command.
*/
-static inline int wv_synchronous_cmd(struct net_device * dev, const char *str)
+static int wv_synchronous_cmd(struct net_device * dev, const char *str)
{
net_local *lp = (net_local *) dev->priv;
unsigned long ioaddr = dev->base_addr;
@@ -633,7 +633,7 @@
* Configuration commands completion interrupt.
* Check if done, and if OK.
*/
-static inline int
+static int
wv_config_complete(struct net_device * dev, unsigned long ioaddr, net_local * lp)
{
unsigned short mcs_addr;
@@ -843,7 +843,7 @@
* wavelan_interrupt is not an option), so you may experience
* delays sometimes.
*/
-static inline void wv_82586_reconfig(struct net_device * dev)
+static void wv_82586_reconfig(struct net_device * dev)
{
net_local *lp = (net_local *) dev->priv;
unsigned long flags;
@@ -1281,7 +1281,7 @@
* This is the information which is displayed by the driver at startup.
* There are lots of flags for configuring it to your liking.
*/
-static inline void wv_init_info(struct net_device * dev)
+static void wv_init_info(struct net_device * dev)
{
short ioaddr = dev->base_addr;
net_local *lp = (net_local *) dev->priv;
@@ -1502,7 +1502,7 @@
* It's a bit complicated and you don't really want to look into it.
* (called in wavelan_ioctl)
*/
-static inline int wv_set_frequency(unsigned long ioaddr, /* I/O port of the card */
+static int wv_set_frequency(unsigned long ioaddr, /* I/O port of the card */
iw_freq * frequency)
{
const int BAND_NUM = 10; /* Number of bands */
@@ -1677,7 +1677,7 @@
/*
* Give the list of available frequencies.
*/
-static inline int wv_frequency_list(unsigned long ioaddr, /* I/O port of the card */
+static int wv_frequency_list(unsigned long ioaddr, /* I/O port of the card */
iw_freq * list, /* List of frequencies to fill */
int max)
{ /* Maximum number of frequencies */
@@ -2489,7 +2489,7 @@
* Note: if any errors occur, the packet is "dropped on the floor".
* (called by wv_packet_rcv())
*/
-static inline void
+static void
wv_packet_read(struct net_device * dev, u16 buf_off, int sksize)
{
net_local *lp = (net_local *) dev->priv;
@@ -2585,7 +2585,7 @@
* (called in wavelan_interrupt()).
* Note : the spinlock is already grabbed for us.
*/
-static inline void wv_receive(struct net_device * dev)
+static void wv_receive(struct net_device * dev)
{
unsigned long ioaddr = dev->base_addr;
net_local *lp = (net_local *) dev->priv;
@@ -2768,7 +2768,7 @@
*
* (called in wavelan_packet_xmit())
*/
-static inline int wv_packet_write(struct net_device * dev, void *buf, short length)
+static int wv_packet_write(struct net_device * dev, void *buf, short length)
{
net_local *lp = (net_local *) dev->priv;
unsigned long ioaddr = dev->base_addr;
@@ -2964,7 +2964,7 @@
* Routine to initialize the Modem Management Controller.
* (called by wv_hw_reset())
*/
-static inline int wv_mmc_init(struct net_device * dev)
+static int wv_mmc_init(struct net_device * dev)
{
unsigned long ioaddr = dev->base_addr;
net_local *lp = (net_local *) dev->priv;
@@ -3136,7 +3136,7 @@
* Start the receive unit.
* (called by wv_hw_reset())
*/
-static inline int wv_ru_start(struct net_device * dev)
+static int wv_ru_start(struct net_device * dev)
{
net_local *lp = (net_local *) dev->priv;
unsigned long ioaddr = dev->base_addr;
@@ -3228,7 +3228,7 @@
*
* (called by wv_hw_reset())
*/
-static inline int wv_cu_start(struct net_device * dev)
+static int wv_cu_start(struct net_device * dev)
{
net_local *lp = (net_local *) dev->priv;
unsigned long ioaddr = dev->base_addr;
@@ -3329,7 +3329,7 @@
*
* (called by wv_hw_reset())
*/
-static inline int wv_82586_start(struct net_device * dev)
+static int wv_82586_start(struct net_device * dev)
{
net_local *lp = (net_local *) dev->priv;
unsigned long ioaddr = dev->base_addr;
@@ -3641,7 +3641,7 @@
* WaveLAN controller (i82586).
* (called by wavelan_close())
*/
-static inline void wv_82586_stop(struct net_device * dev)
+static void wv_82586_stop(struct net_device * dev)
{
net_local *lp = (net_local *) dev->priv;
unsigned long ioaddr = dev->base_addr;