pata_hpt366: remove redundant code
There's no need to clear the fast interrupt bit in hpt366_set_mode()
since we're doing it in hpt366_init_chipset() already.
While at it, rename 'addr1' local variable to 'addr' and
exclude 'ap->port_no' from its calculation as HPT36x are
single-channel-per-function chips.
Signed-off-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/pata_hpt366.c b/drivers/ata/pata_hpt366.c
index 0bd48e8..f6b2858 100644
--- a/drivers/ata/pata_hpt366.c
+++ b/drivers/ata/pata_hpt366.c
@@ -27,7 +27,7 @@
#include <linux/libata.h>
#define DRV_NAME "pata_hpt366"
-#define DRV_VERSION "0.6.7"
+#define DRV_VERSION "0.6.8"
struct hpt_clock {
u8 xfer_mode;
@@ -207,17 +207,8 @@
{
struct hpt_clock *clocks = ap->host->private_data;
struct pci_dev *pdev = to_pci_dev(ap->host->dev);
- u32 addr1 = 0x40 + 4 * (adev->devno + 2 * ap->port_no);
- u32 addr2 = 0x51 + 4 * ap->port_no;
+ u32 addr = 0x40 + 4 * adev->devno;
u32 mask, reg;
- u8 fast;
-
- /* Fast interrupt prediction disable, hold off interrupt disable */
- pci_read_config_byte(pdev, addr2, &fast);
- if (fast & 0x80) {
- fast &= ~0x80;
- pci_write_config_byte(pdev, addr2, fast);
- }
/* determine timing mask and find matching clock entry */
if (mode < XFER_MW_DMA_0)
@@ -240,9 +231,9 @@
* on-chip PIO FIFO/buffer (and PIO MST mode as well) to avoid
* problems handling I/O errors later.
*/
- pci_read_config_dword(pdev, addr1, ®);
+ pci_read_config_dword(pdev, addr, ®);
reg = ((reg & ~mask) | (clocks->timing & mask)) & ~0xc0000000;
- pci_write_config_dword(pdev, addr1, reg);
+ pci_write_config_dword(pdev, addr, reg);
}
/**