PCI/PM/Runtime: make PCI traces quieter
When the runtime PM is activated on PCI, if a device switches state
frequently (e.g. an EHCI controller with autosuspending USB devices
connected) the PCI configuration traces might be very verbose in the
kernel log. Let's guard those traces with DEBUG condition.
Acked-by: "Rafael J. Wysocki" <rjw@sisk.pl>
Signed-off-by: Vincent Palatin <vpalatin@chromium.org>
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
diff --git a/drivers/acpi/pci_irq.c b/drivers/acpi/pci_irq.c
index 7f9eba9..0eefa12 100644
--- a/drivers/acpi/pci_irq.c
+++ b/drivers/acpi/pci_irq.c
@@ -487,10 +487,10 @@
else
link_desc[0] = '\0';
- dev_info(&dev->dev, "PCI INT %c%s -> GSI %u (%s, %s) -> IRQ %d\n",
- pin_name(pin), link_desc, gsi,
- (triggering == ACPI_LEVEL_SENSITIVE) ? "level" : "edge",
- (polarity == ACPI_ACTIVE_LOW) ? "low" : "high", dev->irq);
+ dev_dbg(&dev->dev, "PCI INT %c%s -> GSI %u (%s, %s) -> IRQ %d\n",
+ pin_name(pin), link_desc, gsi,
+ (triggering == ACPI_LEVEL_SENSITIVE) ? "level" : "edge",
+ (polarity == ACPI_ACTIVE_LOW) ? "low" : "high", dev->irq);
return 0;
}
@@ -524,6 +524,6 @@
* (e.g. PCI_UNDEFINED_IRQ).
*/
- dev_info(&dev->dev, "PCI INT %c disabled\n", pin_name(pin));
+ dev_dbg(&dev->dev, "PCI INT %c disabled\n", pin_name(pin));
acpi_unregister_gsi(gsi);
}
diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c
index 5c5adef..54343aa 100644
--- a/drivers/pci/pci.c
+++ b/drivers/pci/pci.c
@@ -973,7 +973,7 @@
for (i = 15; i >= 0; i--) {
pci_read_config_dword(dev, i * 4, &val);
if (val != dev->saved_config_space[i]) {
- dev_printk(KERN_DEBUG, &dev->dev, "restoring config "
+ dev_dbg(&dev->dev, "restoring config "
"space at offset %#x (was %#x, writing %#x)\n",
i, val, (int)dev->saved_config_space[i]);
pci_write_config_dword(dev,i * 4,
@@ -1542,8 +1542,7 @@
}
out:
- dev_printk(KERN_DEBUG, &dev->dev, "PME# %s\n",
- enable ? "enabled" : "disabled");
+ dev_dbg(&dev->dev, "PME# %s\n", enable ? "enabled" : "disabled");
}
/**
diff --git a/drivers/pci/setup-res.c b/drivers/pci/setup-res.c
index 5717509b..b66bfdb 100644
--- a/drivers/pci/setup-res.c
+++ b/drivers/pci/setup-res.c
@@ -85,9 +85,9 @@
}
}
res->flags &= ~IORESOURCE_UNSET;
- dev_info(&dev->dev, "BAR %d: set to %pR (PCI address [%#llx-%#llx])\n",
- resno, res, (unsigned long long)region.start,
- (unsigned long long)region.end);
+ dev_dbg(&dev->dev, "BAR %d: set to %pR (PCI address [%#llx-%#llx])\n",
+ resno, res, (unsigned long long)region.start,
+ (unsigned long long)region.end);
}
int pci_claim_resource(struct pci_dev *dev, int resource)