[SCSI] tmscsim: remove long dead DMA_INT
DMA_INT code is disabled since 1998, remove it to prepare
for further cleanup.
Signed-off-by: G. Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/tmscsim.c b/drivers/scsi/tmscsim.c
index 3158949..bc0a007 100644
--- a/drivers/scsi/tmscsim.c
+++ b/drivers/scsi/tmscsim.c
@@ -625,70 +625,6 @@
return 0;
}
-//#define DMA_INT EN_DMA_INT /*| EN_PAGE_INT*/
-#define DMA_INT 0
-
-#if DMA_INT
-/* This is similar to AM53C974.c ... */
-static u8
-dc390_dma_intr (struct dc390_acb* pACB)
-{
- struct dc390_srb* pSRB;
- u8 dstate;
- DEBUG0(u16 pstate; struct pci_dev *pdev = pACB->pdev);
-
- DEBUG0(pci_read_config_word(pdev, PCI_STATUS, &pstate));
- DEBUG0(if (pstate & (PCI_STATUS_SIG_SYSTEM_ERROR | PCI_STATUS_DETECTED_PARITY))\
- { printk(KERN_WARNING "DC390: PCI state = %04x!\n", pstate); \
- pci_write_config_word(pdev, PCI_STATUS, (PCI_STATUS_SIG_SYSTEM_ERROR | PCI_STATUS_DETECTED_PARITY));});
-
- dstate = DC390_read8 (DMA_Status);
-
- if (! pACB->pActiveDCB || ! pACB->pActiveDCB->pActiveSRB) return dstate;
- else pSRB = pACB->pActiveDCB->pActiveSRB;
-
- if (dstate & (DMA_XFER_ABORT | DMA_XFER_ERROR | POWER_DOWN | PCI_MS_ABORT))
- {
- printk (KERN_ERR "DC390: DMA error (%02x)!\n", dstate);
- return dstate;
- }
- if (dstate & DMA_XFER_DONE)
- {
- u32 residual, xferCnt; int ctr = 6000000;
- if (! (DC390_read8 (DMA_Cmd) & READ_DIRECTION))
- {
- do
- {
- DEBUG1(printk (KERN_DEBUG "DC390: read residual bytes ... \n"));
- dstate = DC390_read8 (DMA_Status);
- residual = DC390_read8 (CtcReg_Low) | DC390_read8 (CtcReg_Mid) << 8 |
- DC390_read8 (CtcReg_High) << 16;
- residual += DC390_read8 (Current_Fifo) & 0x1f;
- } while (residual && ! (dstate & SCSI_INTERRUPT) && --ctr);
- if (!ctr) printk (KERN_CRIT "DC390: dma_intr: DMA aborted unfinished: %06x bytes remain!!\n", DC390_read32 (DMA_Wk_ByteCntr));
- /* residual = ... */
- }
- else
- residual = 0;
-
- /* ??? */
-
- xferCnt = pSRB->SGToBeXferLen - residual;
- pSRB->SGBusAddr += xferCnt;
- pSRB->TotalXferredLen += xferCnt;
- pSRB->SGToBeXferLen = residual;
-# ifdef DC390_DEBUG0
- printk (KERN_INFO "DC390: DMA: residual = %i, xfer = %i\n",
- (unsigned int)residual, (unsigned int)xferCnt);
-# endif
-
- DC390_write8 (DMA_Cmd, DMA_IDLE_CMD);
- }
- dc390_laststatus &= ~0xff000000; dc390_laststatus |= dstate << 24;
- return dstate;
-}
-#endif
-
static void __inline__
dc390_InvalidCmd(struct dc390_acb* pACB)
@@ -708,9 +644,6 @@
u8 phase;
void (*stateV)( struct dc390_acb*, struct dc390_srb*, u8 *);
u8 istate, istatus;
-#if DMA_INT
- u8 dstatus;
-#endif
sstatus = DC390_read8 (Scsi_Status);
if( !(sstatus & INTERRUPT) )
@@ -718,22 +651,9 @@
DEBUG1(printk (KERN_DEBUG "sstatus=%02x,", sstatus));
-#if DMA_INT
- spin_lock_irq(pACB->pScsiHost->host_lock);
- dstatus = dc390_dma_intr (pACB);
- spin_unlock_irq(pACB->pScsiHost->host_lock);
-
- DEBUG1(printk (KERN_DEBUG "dstatus=%02x,", dstatus));
- if (! (dstatus & SCSI_INTERRUPT))
- {
- DEBUG0(printk (KERN_WARNING "DC390 Int w/o SCSI actions (only DMA?)\n"));
- return IRQ_NONE;
- }
-#else
//DC390_write32 (DMA_ScsiBusCtrl, WRT_ERASE_DMA_STAT | EN_INT_ON_PCI_ABORT);
//dstatus = DC390_read8 (DMA_Status);
//DC390_write32 (DMA_ScsiBusCtrl, EN_INT_ON_PCI_ABORT);
-#endif
spin_lock_irq(pACB->pScsiHost->host_lock);
@@ -879,7 +799,7 @@
}
if ((*psstatus & 7) != SCSI_DATA_OUT)
{
- DC390_write8 (DMA_Cmd, WRITE_DIRECTION+DMA_IDLE_CMD); /* | DMA_INT */
+ DC390_write8 (DMA_Cmd, WRITE_DIRECTION+DMA_IDLE_CMD);
DC390_write8 (ScsiCmd, CLEAR_FIFO_CMD);
}
}
@@ -924,7 +844,7 @@
+ ((unsigned long) DC390_read8 (CtcReg_Low)));
DEBUG1(printk (KERN_DEBUG "Count_2_Zero (ResidCnt=%i,ToBeXfer=%li),", ResidCnt, pSRB->SGToBeXferLen));
- DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD); /* | DMA_INT */
+ DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD);
pSRB->TotalXferredLen += pSRB->SGToBeXferLen;
pSRB->SGIndex++;
@@ -973,7 +893,7 @@
}
/* It seems a DMA Blast abort isn't that bad ... */
if (!i) printk (KERN_ERR "DC390: DMA Blast aborted unfinished!\n");
- //DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD); /* | DMA_INT */
+ //DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD);
dc390_laststatus &= ~0xff000000; dc390_laststatus |= bval << 24;
DEBUG1(printk (KERN_DEBUG "Blast: Read %i times DMA_Status %02x", 0xa000-i, bval));
@@ -1013,7 +933,7 @@
if ((*psstatus & 7) != SCSI_DATA_IN)
{
DC390_write8 (ScsiCmd, CLEAR_FIFO_CMD);
- DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD); /* | DMA_INT */
+ DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD);
}
}
@@ -1391,7 +1311,7 @@
if( pSRB->SGIndex < pSRB->SGcount )
{
- DC390_write8 (DMA_Cmd, DMA_IDLE_CMD | ioDir /* | DMA_INT */);
+ DC390_write8 (DMA_Cmd, DMA_IDLE_CMD | ioDir);
if( !pSRB->SGToBeXferLen )
{
psgl = pSRB->pSegmentList;
@@ -1410,12 +1330,12 @@
DC390_write32 (DMA_XferCnt, pSRB->SGToBeXferLen);
DC390_write32 (DMA_XferAddr, pSRB->SGBusAddr);
- //DC390_write8 (DMA_Cmd, DMA_IDLE_CMD | ioDir); /* | DMA_INT; */
+ //DC390_write8 (DMA_Cmd, DMA_IDLE_CMD | ioDir);
pSRB->SRBState = SRB_DATA_XFER;
DC390_write8 (ScsiCmd, DMA_COMMAND+INFO_XFER_CMD);
- DC390_write8 (DMA_Cmd, DMA_START_CMD | ioDir | DMA_INT);
+ DC390_write8 (DMA_Cmd, DMA_START_CMD | ioDir);
//DEBUG1(DC390_write32 (DMA_ScsiBusCtrl, WRT_ERASE_DMA_STAT | EN_INT_ON_PCI_ABORT));
//DEBUG1(printk (KERN_DEBUG "DC390: DMA_Status: %02x\n", DC390_read8 (DMA_Status)));
//DEBUG1(DC390_write32 (DMA_ScsiBusCtrl, EN_INT_ON_PCI_ABORT));
@@ -1436,8 +1356,8 @@
pSRB->SRBState |= SRB_XFERPAD;
DC390_write8 (ScsiCmd, DMA_COMMAND+XFER_PAD_BYTE);
/*
- DC390_write8 (DMA_Cmd, DMA_IDLE_CMD | ioDir); // | DMA_INT;
- DC390_write8 (DMA_Cmd, DMA_START_CMD | ioDir | DMA_INT);
+ DC390_write8 (DMA_Cmd, DMA_IDLE_CMD | ioDir);
+ DC390_write8 (DMA_Cmd, DMA_START_CMD | ioDir);
*/
}
}