batman-adv: Ignore 80-chars per line limits for strings
Signed-off-by: Sven Eckelmann <sven@narfation.org>
Signed-off-by: Marek Lindner <lindner_marek@yahoo.de>
diff --git a/net/batman-adv/hard-interface.c b/net/batman-adv/hard-interface.c
index 409d027..3778977 100644
--- a/net/batman-adv/hard-interface.c
+++ b/net/batman-adv/hard-interface.c
@@ -175,11 +175,9 @@
net_dev->dev_addr))
continue;
- pr_warning("The newly added mac address (%pM) already exists "
- "on: %s\n", net_dev->dev_addr,
- hard_iface->net_dev->name);
- pr_warning("It is strongly recommended to keep mac addresses "
- "unique to avoid problems!\n");
+ pr_warning("The newly added mac address (%pM) already exists on: %s\n",
+ net_dev->dev_addr, hard_iface->net_dev->name);
+ pr_warning("It is strongly recommended to keep mac addresses unique to avoid problems!\n");
}
rcu_read_unlock();
}
@@ -282,10 +280,7 @@
/* hard-interface is part of a bridge */
if (hard_iface->net_dev->priv_flags & IFF_BRIDGE_PORT)
- pr_err("You are about to enable batman-adv on '%s' which "
- "already is part of a bridge. Unless you know exactly "
- "what you are doing this is probably wrong and won't "
- "work the way you think it would.\n",
+ pr_err("You are about to enable batman-adv on '%s' which already is part of a bridge. Unless you know exactly what you are doing this is probably wrong and won't work the way you think it would.\n",
hard_iface->net_dev->name);
soft_iface = dev_get_by_name(&init_net, iface_name);
@@ -303,8 +298,7 @@
}
if (!softif_is_valid(soft_iface)) {
- pr_err("Can't create batman mesh interface %s: "
- "already exists as regular interface\n",
+ pr_err("Can't create batman mesh interface %s: already exists as regular interface\n",
soft_iface->name);
dev_put(soft_iface);
ret = -EINVAL;
@@ -317,8 +311,9 @@
bat_priv->bat_algo_ops->bat_ogm_init(hard_iface);
if (!hard_iface->packet_buff) {
- bat_err(hard_iface->soft_iface, "Can't add interface packet "
- "(%s): out of memory\n", hard_iface->net_dev->name);
+ bat_err(hard_iface->soft_iface,
+ "Can't add interface packet (%s): out of memory\n",
+ hard_iface->net_dev->name);
ret = -ENOMEM;
goto err;
}
@@ -341,29 +336,22 @@
if (atomic_read(&bat_priv->fragmentation) && hard_iface->net_dev->mtu <
ETH_DATA_LEN + BAT_HEADER_LEN)
bat_info(hard_iface->soft_iface,
- "The MTU of interface %s is too small (%i) to handle "
- "the transport of batman-adv packets. Packets going "
- "over this interface will be fragmented on layer2 "
- "which could impact the performance. Setting the MTU "
- "to %zi would solve the problem.\n",
+ "The MTU of interface %s is too small (%i) to handle the transport of batman-adv packets. Packets going over this interface will be fragmented on layer2 which could impact the performance. Setting the MTU to %zi would solve the problem.\n",
hard_iface->net_dev->name, hard_iface->net_dev->mtu,
ETH_DATA_LEN + BAT_HEADER_LEN);
if (!atomic_read(&bat_priv->fragmentation) && hard_iface->net_dev->mtu <
ETH_DATA_LEN + BAT_HEADER_LEN)
bat_info(hard_iface->soft_iface,
- "The MTU of interface %s is too small (%i) to handle "
- "the transport of batman-adv packets. If you "
- "experience problems getting traffic through try "
- "increasing the MTU to %zi.\n",
+ "The MTU of interface %s is too small (%i) to handle the transport of batman-adv packets. If you experience problems getting traffic through try increasing the MTU to %zi.\n",
hard_iface->net_dev->name, hard_iface->net_dev->mtu,
ETH_DATA_LEN + BAT_HEADER_LEN);
if (hardif_is_iface_up(hard_iface))
hardif_activate_interface(hard_iface);
else
- bat_err(hard_iface->soft_iface, "Not using interface %s "
- "(retrying later): interface not active\n",
+ bat_err(hard_iface->soft_iface,
+ "Not using interface %s (retrying later): interface not active\n",
hard_iface->net_dev->name);
/* begin scheduling originator messages on that interface */