usb: musb: Remove extra PM runtime calls from 2430 glue layer
With PM runtime behaving, these are all now unnecessary.
Doing pm_runtime_get(musb->controller) will keep the parent
glue layer also active.
Signed-off-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Bin Liu <b-liu@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c
index 2c54f52..22f15b0 100644
--- a/drivers/usb/musb/omap2430.c
+++ b/drivers/usb/musb/omap2430.c
@@ -268,13 +268,8 @@
{
struct omap2430_glue *glue = container_of(mailbox_work,
struct omap2430_glue, omap_musb_mailbox_work);
- struct musb *musb = glue_to_musb(glue);
- struct device *dev = musb->controller;
- pm_runtime_get_sync(dev);
omap_musb_set_mailbox(glue);
- pm_runtime_mark_last_busy(dev);
- pm_runtime_put_autosuspend(dev);
}
static irqreturn_t omap2430_musb_interrupt(int irq, void *__hci)
@@ -343,16 +338,6 @@
musb->isr = omap2430_musb_interrupt;
phy_init(musb->phy);
- /*
- * Enable runtime PM for musb parent (this driver). We can't
- * do it earlier as struct musb is not yet allocated and we
- * need to touch the musb registers for runtime PM.
- */
- pm_runtime_enable(glue->dev);
- status = pm_runtime_get_sync(glue->dev);
- if (status < 0)
- goto err1;
-
l = musb_readl(musb->mregs, OTG_INTERFSEL);
if (data->interface_type == MUSB_INTERFACE_UTMI) {
@@ -376,11 +361,7 @@
if (glue->status != MUSB_UNKNOWN)
omap_musb_set_mailbox(glue);
- pm_runtime_put(glue->dev);
return 0;
-
-err1:
- return status;
}
static void omap2430_musb_enable(struct musb *musb)
@@ -588,11 +569,9 @@
goto err2;
}
- /*
- * Note that we cannot enable PM runtime yet for this
- * driver as we need struct musb initialized first.
- * See omap2430_musb_init above.
- */
+ pm_runtime_enable(glue->dev);
+ pm_runtime_use_autosuspend(glue->dev);
+ pm_runtime_set_autosuspend_delay(glue->dev, 500);
ret = platform_device_add(musb);
if (ret) {
@@ -618,6 +597,7 @@
platform_device_unregister(glue->musb);
omap2430_set_power(musb, false, false);
pm_runtime_put_sync(glue->dev);
+ pm_runtime_dont_use_autosuspend(glue->dev);
pm_runtime_disable(glue->dev);
return 0;