libata: Add a per-host flag to opt-in into parallel port probes
This patch adds a per host flag that allows drivers to opt in into
having its busses scanned in parallel.
Drivers that do not set this flag get their ports scanned in
the "original" sequence.
Signed-off-by: Arjan van de Ven <arjan@linux.intel.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index 7f701cb..9603967 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -2660,6 +2660,9 @@
host->iomap = pcim_iomap_table(pdev);
host->private_data = hpriv;
+ if (!(hpriv->cap & HOST_CAP_SSS))
+ host->flags |= ATA_HOST_PARALLEL_SCAN;
+
if (pi.flags & ATA_FLAG_EM)
ahci_reset_em(host);
diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
index c507a9a..f810078 100644
--- a/drivers/ata/libata-core.c
+++ b/drivers/ata/libata-core.c
@@ -5920,6 +5920,15 @@
{
int rc;
struct ata_port *ap = data;
+
+ /*
+ * If we're not allowed to scan this host in parallel,
+ * we need to wait until all previous scans have completed
+ * before going further.
+ */
+ if (!(ap->host->flags & ATA_HOST_PARALLEL_SCAN))
+ async_synchronize_cookie(cookie);
+
/* probe */
if (ap->ops->error_handler) {
struct ata_eh_info *ehi = &ap->link.eh_info;
diff --git a/include/linux/libata.h b/include/linux/libata.h
index 4f7c8fb..b6b8a7f 100644
--- a/include/linux/libata.h
+++ b/include/linux/libata.h
@@ -239,6 +239,7 @@
/* host set flags */
ATA_HOST_SIMPLEX = (1 << 0), /* Host is simplex, one DMA channel per host only */
ATA_HOST_STARTED = (1 << 1), /* Host started */
+ ATA_HOST_PARALLEL_SCAN = (1 << 2), /* Ports on this host can be scanned in parallel */
/* bits 24:31 of host->flags are reserved for LLD specific flags */