KVM: PPC: Work around POWER7 DABR corruption problem
It turns out that on POWER7, writing to the DABR can cause a corrupted
value to be written if the PMU is active and updating SDAR in continuous
sampling mode. To work around this, we make sure that the PMU is inactive
and SDAR updates are disabled (via MMCRA) when we are context-switching
DABR.
When the guest sets DABR via the H_SET_DABR hypercall, we use a slightly
different workaround, which is to read back the DABR and write it again
if it got corrupted.
While we are at it, make it consistent that the saving and restoring
of the guest's non-volatile GPRs and the FPRs are done with the guest
setup of the PMU active.
Signed-off-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Avi Kivity <avi@redhat.com>
diff --git a/arch/powerpc/kvm/book3s_hv_interrupts.S b/arch/powerpc/kvm/book3s_hv_interrupts.S
index d3fb4df..84035a5 100644
--- a/arch/powerpc/kvm/book3s_hv_interrupts.S
+++ b/arch/powerpc/kvm/book3s_hv_interrupts.S
@@ -68,19 +68,24 @@
rotldi r10,r10,16
mtmsrd r10,1
- /* Save host PMU registers and load guest PMU registers */
+ /* Save host PMU registers */
/* R4 is live here (vcpu pointer) but not r3 or r5 */
li r3, 1
sldi r3, r3, 31 /* MMCR0_FC (freeze counters) bit */
mfspr r7, SPRN_MMCR0 /* save MMCR0 */
mtspr SPRN_MMCR0, r3 /* freeze all counters, disable interrupts */
+ mfspr r6, SPRN_MMCRA
+BEGIN_FTR_SECTION
+ /* On P7, clear MMCRA in order to disable SDAR updates */
+ li r5, 0
+ mtspr SPRN_MMCRA, r5
+END_FTR_SECTION_IFSET(CPU_FTR_ARCH_206)
isync
ld r3, PACALPPACAPTR(r13) /* is the host using the PMU? */
lbz r5, LPPACA_PMCINUSE(r3)
cmpwi r5, 0
beq 31f /* skip if not */
mfspr r5, SPRN_MMCR1
- mfspr r6, SPRN_MMCRA
std r7, HSTATE_MMCR(r13)
std r5, HSTATE_MMCR + 8(r13)
std r6, HSTATE_MMCR + 16(r13)